MITSUBISHI PAJERO 07
Transcription
MITSUBISHI PAJERO 07
MITSUBISHI PAJERO 07 Item Code Codice Articolo Réference Article : MA/194/IX MA/K/194/IX GB ITA STAINLESS STEEL HIGH MEDIUM BAR MEDIUM BAR ALTO IN ACCIAIO INOX FR MEDIUM BAR HAUT EN ACCIER INOX MITSUBISHI PAJERO 07 Part List Lista della bulloneria Liste des piéces A TE 8x60 F x 2 B Ø 8 G x 4 C Ø 8 106 E x 2 TE 6x25 x 2 x 2 Ø 6 x 2 H x 4 D Ø 6 Grande Big Grand T B C E I 8x20 x 2 I M8 L x 2 MA/194/B x 2 GB FITTING INSTRUCTIONS ITA ISTRUZIONI DI MONTAGGIO FR INSTRUCTIONS DE MONTAGE PARTIE INFERIEURE 1. Remove the numberplate and numberplate holder to free the n.2 holes indicated in picture 1. 1. Rimuovere la targa ed il porta targa per liberare i n.2 fori indicati in foto 1. 2. Remove the n.2 TE that hold the sheet metal protection located below the front bumper indicated in picture 2. 2. Rimuovere i n.2 TE che sorreggono la protezione in lamiera presente sotto il paraurti anteriore come indicato nella foto 2. 3. Fit the L brackets in the holes previously freed removing the numberplate holder using F and C and reassemble the numberplate holder. 3. Montare le staffe L nei fori precedentemente liberati tramite la rimozione del porta targa utilizzando F e C e rimontare il porta targa. 4. Fit the lower welded brackets in the holes freed at point 2 using A,B,C and D as shown in picture 3. 4. Montare le staffe inferiori saldate nei fori liberati al punto 2 utilizzando A,B,C e D come indicato nella foto 3. 4. Monter les étriers inférieurs saudés dans les trous libérés au point 2 en utilsant A,B,C et D comme indiqué dans la photo 3. 5. Fit the L brackets in the holes present on the central plate of the medium bar (picture 4) using I,C,B and H. 5. Montare le staffe L nei fori presenti sulla piastra centrale del MEDIUM BAR ALTO (foto 4) utilizzando I,C,B e H. 5. Monter les étriers L dans les trous présents sûr la plaque centrale du medium bar haut (photo 4) en utilisant I,C,B et H. 6. Tighten all the set of bolts. 6. Serrare tutta la bulloneria. 6. 1. Enlever la plaque d’immatriculation et le porte plaque d’immatriculation pour libérer les n.2 trous indiqués dans la photo 1. 2. Enlever les n.1 TE qui soutiennent la protection en fer presente sous le parechoc antérieur comme indiqué dans la photo 2. 3. Monter les étriers L dans les trous précédemment libérés en enlevant le porte plaque d’immatriculation en utilisant F et C et remonter le porte plaque d’immatriculation. Serrer toute la boulonnerie. 1 2 4 Date Data Date 30/01/07 Item Code Cod.Articolo Réf. Article MA/194/IX MA/K/194/IX Checked and approved by Controllato ed approvato da Controlé et approuvé par Vehicle model Modello Veicolo Modèle de Voiture MITSUBISHI PAJERO 07 Claudio Gallo 3