EasyCoder® PD41/PD42
Transcription
EasyCoder® PD41/PD42
EasyCoder® PD41/PD42 EasyLAN Ethernet Interface Installation Instructions These instructions tell you how to install the EasyLAN Ethernet Interface Board in a EasyCoder PD41/PD42 printer. The kit includes the following: • EasyLAN Ethernet Interface Board Required Tools To install the interface board in your printer, you need these tools: • Screwdriver, slotted • Screwdriver, Phillips Installing the Interface Board Before you begin installation, please acknowledge the following important safety notes: The installation described in this section must only be performed by an authorized service technician. Intermec assumes no responsibility for personal injury or damage to the equipment if the installation is performed by an unauthorized person. Die in diesem Abschnitt beschriebene Installation darf nur von einem autorisierten Wartungstechniker durchgeführt werden. Intermec übernimmt keine Verantwortung für Verletzungen oder Sachschäden, falls die Installation von einer unberechtigten Person durchgeführt wird. Make sure the printer has been turned off and disconnected from the power supply before you start installation. Stellen Sie sicher, dass der Drucker abgeschaltet und von der Stromversorgung abgetrennt wurde, bevor Sie mit der Installation beginnen. Take precautions against electrostatic discharge, for example, by wearing grounded wrist straps. To install the EasyLAN Ethernet Interface Board 1 Turn off the printer and unplug the power cord. 2 Open the side door. Remove the two screws that hold the cover to the electronics compartment. 3 Lay the printer down on its side, with the electronics compartment facing up. 4 Loosen the electronics compartment cover by placing the tip of a slotted screwdriver at the edge of the cover and gently pushing the handle towards the top of the printer. DO NOT attempt to bend it loose. 5 Slide the cover out along the rails and remove it from the printer. 6 Put the printer back in upright position. 7 Locate the screw in the upper left corner of the electronics compartment that holds the main board in place. Remove the screw. 8 Connect the EasyLAN board to the connector marked “Ethernet Option” on the main board. 9 Reattach the screw. 10 Reattach the cover. When you turn on the printer, it automatically recognizes the EasyLAN board. Please refer to the EasyLAN Software Installation Instructions (P/N 1-960667-xx) for information on configuring the network settings. If you have a PD42 printer you can change settings directly from the display, for help see the EasyCoder PD42 Printer User’s Guide (P/N 934-009-xxx). Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com © 2007 Intermec Technologies Corporation. All rights reserved. EasyCoder PD41/PD42 EasyLAN Ethernet Interface Installation Instructions *1-960656-01* P/N 1-960656-01