Manual to use the Orion Decoder and how to make a
Transcription
Manual to use the Orion Decoder and how to make a
Manual to use the Orion Decoder and how to make a Loop 1 Orion Decoder use 1.1 1.2 1.3 1.4 1.5 2 Hardware face Connecting Picture Example of installation How to connect and configure the decoder and the computer Change IP address of the decoder Make a Loop 2.1 2.2 2.3 Loop for circuit Loop for cross Aerian Loop 1 Orion Decoder Use 1.1 Hardware face Rear Face Front Face 1.2 Connecting picture 1: to connect your master s computer 2: to connect your slave s computer 3: to connect your remote control 4: to connect your cell 5: to connect your headphone or your active speaker 6: to connect the stand lane entry loop 7: to connect the finish loop 8: click this button to enter the test mode 9: to connect your network with tcp/ip protocol 10: to connect your power supply 1.3 Example of installation USB CONNECTION TCP/IP CONNECTION WITH OPTIONS 1.4 How to connect and configure the decoder and the computer - Plug the power supply to the connector 12v dc - Plug the USB cable between the computer and the USB master connector Step 1 : Select « Non, pas pour cette fois » and click Next Step 2 : Select « Installer à partir d une liste ou d un emplacement spécifié » and click Next Step 3 : - Inser the Chronos CD - Tick « inclure cette emplacement dans la recherche » - Untick « rechercher dans les médias amovibles » - Click on Browse - Click the Chronos CD - Click on Dongle & USB - Click OK - Click Next - Click Continue - Finally, click on Finish 1.5 How to change the IP address of the Orion Decoder Inside the Windows Explorer address, write the Default address of the decoder 192.168.0.251 Select «Network settings», write you new IP address and then, select «Submit» 2 MAKE A LOOP 2.1 Loop for circuit MX LOOP 2.2 LOOP for Cross and Super-Cross 2.3 Aerian LOOP