Se n so r Fille r Flo w R ate p e r Lin e (Lite rs P e r M in u te ) N
Transcription
Se n so r Fille r Flo w R ate p e r Lin e (Lite rs P e r M in u te ) N
100 200 140 seconds 140 seconds yes 6 2 200 140 seconds Upgradable Time to Fill Two Hole Filling 1 2 One Hole Filling Typical IGs per shift (two hole filling) 6 6 Time to Fill One Hole Filling Number of Lines yes yes Typical IGs per shift (one hole filling) Flow Rate per Line (Liters Per Minute) 1 Sensor Filler 8 SS/ILT GasGlass Air Space Laser RSGa RSGi RSGkr Standard with krypton boards and recovery interface RSGd-1 RSGd-2 RSGd-3 RSGd-4 yes yes yes yes 9-18 9-18 9-18 9-18 1 2 3 4 150 300 450 600 100 seconds yes yes yes Add line to RSGd (per line) Convert RSGd to RSGh Convert existing RSGd lines to RSGh (per line) RSGe yes 15-28 1 250 71 seconds 125-175 110 seconds yes RSGh-1 RSGh-2 RSGh-3 RSGh-4 yes yes yes yes 15-28 15-28 15-28 15-28 1 2 3 4 250 500 750 1000 71 seconds 125-175 250-350 375-500 500-675 110 seconds yes yes yes yes yes yes yes 1 1 1 350 550 1100 61 seconds 38 seconds 14 seconds Add line to RSGh (per line) RSGz40 RSGz90 RSGz175 RSGz90 RSGz175 yes yes yes 20-45 20-90 20-175 Three 4mm holes with two 3.8mm snifflers or two 5.4mm (7/32") holes with 4mm snifflers. A 3.8mm laminar filling lance is always used. Note: There are a large number of variables when considering time to fill. Example given is the result of filling an actual unit. Two 8mm filling holes, one 7.2mm sniffler, and one Unit Size: 7.2mm laminar filling lace. Spacer: 21/32" • 0.665" • 17mm Height: 48" • 1220mm Both z90 and z175 can run as z40 by pressing a Width: 24" • 610mm button and connecting 3.5mm sniffler and 3.5mm Volume: 767 cubic inches • 0.44 cubic feet • 12.6 liters filling lance. 8 square feet •0.74 square meters yes