traffic booster - Graffiti Research Lab France
Transcription
traffic booster - Graffiti Research Lab France
TRAFFIC BOOSTER Accélérateur de traffic urbain http://graffitiresearchlab.fr GUIDE DE FABRICATION Matériel / Components : Outils : - 1 Arduino board / 1 carte Arduino http://www.adafruit.com/products/1086 - Fer à souder Etain Pince coupante Perceuse - 1 LDR http://radiospares-fr.rs-online.com/web/p/ldr/0596141/ Tools : - 1 10k resistor / 1 résistance 10K http://radiospares-fr.rs-online.com/web/p/resistances-traversantes/7550739/ - 1 potentiometer / 1 potentiomètre http://radiospares-fr.rs-online.com/web/p/potentiometres/7703062/ - 2 switches / 2 interrupteurs http://radiospares-fr.rs-online.com/web/p/interrupteurs-a-bascule/0419744/ - 1 2RT 5V 2A relay / 1 relais 2 RT 5V 2A http://radiospares-fr.rs-online.com/web/p/relais-sans-accrochage/6839283/ - 1 car horn / 1 klaxon de voiture http://www.oscaro.com/avertisseur-sonore-bosch-0-986-320-111-79967-297-p - 1 12V battery / Batterie 12V http://radiospares-fr.rs-online.com/web/p/batteries-au-plomb/5375444 - Cable / Câble - Enclosure / Support (boite) - Cap to glue the LDR inside so it is protected from external light sources (cf last page) - Bouchon afin de coller la LDR à l'intérieur afin de la protéger des sources de lumière externes (voir dernière page) - Sodlering iron Solder Wire cutters Drill Arduino : The Arduino code can be found here : Le code Arduino peut être trouvé ici : http://github.com/01010101/TrafficBooster How it works : Attach the Traffic Booster to traffic lights Attach the LDR right in front of the green light, as close as possible, to make sure no external light will prevent it from working properly. Check both switches buttons are OFF. Power on the Arduino board by turning ON the switch attached to the 9V battery's When the traffic light is green : - Turn the potentiometer until the Traffic Booster's red LED is ON - Then turn it slowly on the other side until the Traffic Booster's green LED is ON (and don't go further). - Wait until the traffic light is red. - Turn ON the switch attached to the 12V battery - Have fun Fonctionnement : Accrocher le Traffic Booster à des feux tricolores Attacher la LDR face au feu vert, le plus près possible afin d'éviter les interférences lumineuses externes Vérifier que les 2 interrupteurs sont sur OFF Allumer l'Arduino en actionnant l'interrupteur relié à la batterie 9V Lorsque le feu est au vert : - Tourner le potentiomètre jusqu'à ce que la LED rouge du Traffic Booster's soit allumée - Tourner ensuite doucement dans l'autre sens jusqu'à ce que la LED verte du Traffic Booster s'allume (ne pas aller plus loin) - Attendre que le feu passe au rouge - Mettre l'interrupteur relié à la batterie 12V sur ON Amusez-vous bien LDR enclosure detail Détail du montage de la LDR