sta-brite™ dry bright floor coating
Transcription
sta-brite™ dry bright floor coating
Sta-Brite Floor Coating Page 1 of 4 Revision Date: 13/10/2013 Print Date: 30/07/14 PRODUCT INFORMATON SHEET T STA-BRITE™ DRY BRIGHT FLOOR COATING EQUINOX™ An excellent, low maintenance coating with outstanding resistance to scuffs, scratches, black heel marks and detergent scrubbings. Recommended Floor Surfaces: Vinyl composite tile (“VCT”) flooring. Ideal for floors where ultra high-speed (“UHS”) burnishing Is not practical. DIRECTIONS FOR USE Initial Application 1. Remove old coating and sealer. 2. Neutralize floor using a neutral cleaner or EnviroStar Green™ All Purpose Neutralizer. 3. Rinse floor again with clean, cold water and allow to dry. OPTIONAL: Apply 2 thin coats of sealer to high-traffic areas and old or porous floors. 4. Apply 5-6 coats of STA-BRITE Floor Coating with a clean, synthetic mop. NOTE: Do not exceed an initial application of a combined 6 coats of coating and sealer. 5. Allow floor to dry thoroughly between coats. NOTE: Do not pour unused product from bucket into original container. Routine Maintenance 1. Sweep floor daily with a dust mop. 2. To clean floor use mop or scrubber with neutral cleaner. 3. As needed, perform a deep scrub and re-coat applying an additional 1-2 coats of STA-BRITE Floor Coating. 4. Allow floor to dry thoroughly between coats. 5. Strip floor when desired results cannot be achieved with routine maintenance. PRODUCT DATA Sta-Brite Floor Coating Page 2 of 4 Revision Date: 13/10/2013 Print Date: 30/07/14 SAFETY DATA SHEET Conforms to 1907/2006/EC - (EU) 453/2010 STA-BRITE™ LOW MAINTENANCE FLOOR COATING 1. IDENTIFICATION OF THE MIXTURE (PREPARATION) AND OF THE COMPANY/UNDERTAKING Product Identifier: STA-BRITE™ Low Maintenance Floor Coating Product No.: 130 Product Use: Floor Polish Company: Hugh Crane (Cleaning Equipment) Ltd South Walsham Road, Acle Norwich NR13 3ES Tel 01493 750072 Fax 01493 751854 Relevant Identified Uses Of The Mixture And Uses Advised Against: Floor Polish. Product intended for commercial and industrial use only. 2. HAZARDS IDENTIFICATION Classification Of The Mixture (Preparation) This mixture (preparation) has been classified and labelled according to EC 1272/2008 (1999/45/EC). Label Elements EU Classification: Not classified as hazardous (dangerous) Hazard pictogram (symbol): None Hazard Statements (R- Phrases): None Precautionary Statements (S- phrases): None Other Hazards: No other hazards are known to the supplier. 3. COMPOSITION/INFORMATION ON INGREDIENTS Mixtures: Dangerous Ingredients Ammonium Hydroxide EC No 215-647-6 Weight % 0.1 – 1.0 CAS No 1336-21-6 Symbol C Corrosive Xi Irritant N Dangerous for the Environment R Phrases R34 R36/37/38 R50 See Section 16 for the full text of listed R-Phrases. 4. FIRST AID MEASURES Description Of First Aid Measures Inhalation: If breathing is difficult, remove to fresh air. If symptoms persist, seek medical attention Ingestion: If ingested, do not induce vomiting. Seek medical attention. Skin contact: Wash off with plenty of water. If irritation develops, seek medical attention. Eye contact: Rinse with plenty of water. If irritation develops, seek medical attention. Most Important Symptoms And Effects, Both Acute And Delayed This mixture (preparation) is not expected to produce significant adverse health effects when recommended use instructions are followed. Inhalation: None expected under normal use. Ingestion: None expected under normal use. Skin contact: None expected under normal use. Eye contact: None expected under normal use. Indication Of Any Immediate Medical Attention And Special Treatment Needed No information available. 5. FIRE FIGHTING MEASURES Extinguishing Media: Dry chemical, water spray, foam, carbon dioxide Special Hazards Arising From The Mixture Hazardous combustion products: None Advice For Fire Fighters: Unusual fire and explosion hazards: Materials can splatter above 100°C/212°F. Special Firefighting Procedures: No special firefighting procedures recommended. 6. ACCIDENTAL RELEASE MEASURES Personal Precautions, Protective Eqpt & Emergency Procedures: Refer to Section 8 for appropriate personal protective equipment. Environmental Precautions : Keep spills and cleaning runoff out of sewers and open bodies of water. Sta-Brite Floor Coating Page 3 of 4 Revision Date: 13/10/2013 Print Date: 30/07/14 Methods And Material For Small spills: Absorb spill on inert material (e.g. sand, earth) and dispose of as waste material Containment And Cleaning Up : in accordance with national and regional provisions. Large spills: Keep spectators away. Floors may be slippery; use care to avoid falling. Neutralize spill area. Dike and contain spill with inert material (e.g. sand, earth). Transfer liquid to containers for recovery or disposal and solid diking material to separate containers for disposal. Reference To Other Sections: Refer to Section 8 of the SDS. 7. HANDLING AND STORAGE Precautions For Safe Handling: Avoid contact with eyes and skin. Wash thoroughly after handling. Use in well-ventilated areas. Conditons for safe storage, Storage temperature (Max. 60°C/140°F) (Min. 1°C/34°F). Keep from freezing, product may Including any incompatibilities: coagulate. Keep container sealed when not in use. Keep out of reach of children. Specific End Use(s): No information available. 8. EXPOSURE CONTROL/PERSONAL PROTECTION Control Parameters: Occupation Exposure limits: None established for components Exposure Controls Engineering Controls: Ensure adequate general ventilation. Environmental Exposure Controls: No specific environmental exposure controls required. Personal Protection Respiratory protection: Hand protection: Eye protection: Skin protection: No specific personal protection is required. Rubber gloves recommended Safety glasses recommended If major exposure is possible, wear suitable protective clothing such as rubber boots, apron, etc. 9. PHYSICAL AND CHEMICAL PROPERTIES Information On Basic Physical And Chemical Properties Appearance: Thin, milky white, opaque liquid Odour: Slight ammonia Odour threshold: N/E pH: 8.7 Melting point/Freezing Point: N/A Initial boiling point/boiling range: 100°C Flash point: >93ºC Evaporation Rate: less than water Upper/Lower Flammability/Explosive Limits: N/A Vapour Pressure: less than water Vapour Density: greater than air Relative Density: 1.03 kg/L @ 20ºC Solubility: 100% soluble in water Partition Coefficient (n-octanol/water): N/E Auto-ignition Temperature: N/A Decomposition Temperature: N/E Viscosity: <10 centipoise @ 20ºC Explosive Properties: N/A Oxidizing Properties: Not an oxidizer Other Information VOC: 0.01% 10. STABILITY AND REACTIVITY Reactivity: None known Chemical stability: Stable under normal conditions. Possibility of hazardous reactions: None known. Conditions to avoid: None known. Incompatible materials: None known. Hazardous decomposition products: None known. 11. TOXICOLOGICAL INFORMATION Information On Toxicological Effects Mixture (Preparation) Summary: Toxicity testing has not been completed on the mixture. Local Effects Skin Contact: Eye Contact: Sensitization: Chronic Effects: None expected None expected None expected None expected Specific Effects Carcinogenicity: Reproductive effects: Teratogenicity: Mutagenicity: None known None known None known None known Sta-Brite Floor Coating Page 4 of 4 Revision Date: 13/10/2013 Print Date: 30/07/14 Component Summary * - Ammonium Hydroxide CAS No. 1336-21-6: LD50 (Oral, Rat) 350 mg/kg Potential Health Effects Eye Contact: Skin Contact: Ingestion: Inhalation: Chronic: Carcinogenicity: Vapours cause irritation Causes irritation and burns to the skin. May cause corrosion to the oesophagus and stomach. Vapours and mists cause irritation to the respiratory tract. Repeat exposure may cause damage to the mucous membranes, respiratory tract, eyes and skin. Not listed as a carcinogen. * Component data recorded from available sources pertaining to individual component CAS number. 12. ECOLOGICAL INFORMATION Mixture (Preparation) Summary: Ecological testing has not been completed on the mixture. Toxicity: No data available. Persistence and degradability: No data available. Bioaccumulative potential: No data available. Mobility in soil: No data available. Results Of PBT & vPvB Assessment: No data available. Other Adverse Effects: No data available. Component Summary * - Ammonium Hydroxide CAS No. 1336-21-6: LC50 96hr Fathead Minnow 8.2 mg/l EC50 48hr Daphnia Magna 0.66 mg/l Environmental Fate: Not expected to bioaccumulate. * Component data recorded from available sources pertaining to individual component CAS number. 13. DISPOSAL CONSIDERATIONS Waste Treatment Methods: Disposal of this material should be in accordance with local, regional and national regulations. 14. TRANSPORT INFORMATION Not regulated for transport. Follow all local, regional and national recommendations for transport of non-hazardous chemical products. UN No.: N/A UN Proper Shipping Name: N/A Transport Hazard Classes: N/A Packing Group: N/A Environmental Hazards: N/A Special Precautions For User: N/A Transport In Bulk According To Annex II of MARPOL 73/78 and the IBC Code: N/A 15. REGULATORY INFORMATION Safety, Health And Environmental Regulations/Legislation Specific For The Mixture EINECS Status: Ingredients are included in the EINECS/ELINCS/NLP inventories. National Regulations: No additional national regulations are known to the supplier. Chemical Safety Assessment: No information available. 16. OTHER INFORMATION Revision Date: 13 October 2013 – revision conforming to 1907/2006/EC amendment 453/2010 Annex I Abbreviations: N/A = Not Applicable N/E = Not Established N/L = Not Listed Full Text Of Hazard Statements (R-Phrases): R34 Causes burns. R36 irritating to eyes. R37 Irritating to respiratory system. R38 Irritating to skin. R50 Very toxic to aquatic organisms. Full Text Of Precautionary Statements (S-Phrases): S1/2 Keep locked up and out of reach of children. S26 In case of contact with eyes, rinse immediately with plenty of water & seek medical advice. S37 Wear suitable gloves S39 Wear suitable eye/face protection. S45 In case of accident or if you feel unwell, seek medical advice immediately. (Show the label where possible.) S61 Avoid release to the environment. Refer to special instructions/Safety Data Sheet. End of Safety Data Sheet