Spec Sheet - American Standard
Transcription
Spec Sheet - American Standard
Verdi Series SHOWER SYSTEMS Quadro MODEL NUMBER: 5438 Slide Bar, Showerhead and Valve NOTE: CAN NOT BE USED WITH A DIVERTER SPOUT! It is recommended not to use a TWIN ELL. 1/2" NPT R433SS VALVE 1625-1829mm (64”-72”) 1/2" NPT Typical Stud 133mm (5-1/4) TO SHOWERHEAD 1829-1981mm (72”-78”) TO HAND SHOWER 1/2" PLUG 100mm (4) 4-1/32 1372mm (54”) 1/2" PLUG 156mm (6-5/32) HOT 1067-1219mm 42”-48” 1/2" MALE NPT OR 1/2” NOM. COPPER SWEAT 1/2" PLUG 100mm (4) 44mm (1-3/4) 19mm Min. To 38mm Max. (3/4 Min. To 1-1/2” Max) 155.5mm (6-1/8) COLD FINISHED FLOOR GENERAL DESCRIPTION: Cast brass valve body with integral ceramic disc diverter provides a 2/3 way and (4-6 mode) positions, and a thermostatic temperature control handle, cycling counter clockwise from an On/Off position to full hot. Desired temperature can be set at any time. The temperature is mantain by a wax element moving the piston valve between the hot and cold. The volume is controlled by two ceramic disc valve cartridge. The decorative escutcheon plate is a stamped brass. Valve delivers a high flow rate of: - 10 gpm / 45.4 L/min. @ 45 psi from Tub Port - 9.6 gpm / 43.5 L/min. @ 45 psi from Shower Port - 8.2 gpm / 37 L/min. @ 45 psi from Diverter Port PRODUCT FEATURES: Reversable Thermostatic Cartridge By removing the cartridge and turning it 180 degrees and restalling will correct the water flow in installations where “HOT” and “COLD” lines have been crossed. Built in integral stop allowing to shut off the water at any time. Cartridges are constructed of engineered plastic resistant to lime deposit, rust or any type of hard water. Product names listed herein are trademarks of American Standard © 2009 American Standard FINISHED WALL Cartridge is easily serviceable after installation. Ideal for back to back installation. Valve Equipped with built in service stops and check valves ideal to shut the water off at the body. Standard connections for 1/2” male NPT or 1/2” copper pipe solder. Diverter Ceramic disc diverter provides a share 50/50 and shut off. Easily serviceable after installation. Ideal for back to back installation. Can be used as a 2 or 3 way (4-6 mode). 2 Way = 100% Shower outlet 4 Mode = 50/50 Shower outlet and Hand shower = 100% Hand shower outlet = Off 3 Way = 100% Optional Thrid outlet 6 Mode = 50/50 Optional Thrid outlet and Showerhead = 100% Showerhead = 50/50 Showerhead Hand shower = 100% Hand shower = Off THERMOSTATS FBS - Quadro 5438 Slide Bar, Showerhead and Valve Thermostatic Valve Flow Rate (gpm) CODES AND STANDARDS ASSE 1016 ASME A112.18.1M IAPMO (cUPC) 13.00 12.00 FLOW RATE (gpm) These products meet or exceed the following codes and standards: 11.00 10.00 9.00 8.00 7.00 6.00 5.00 4.00 3.00 2.00 1.00 0.00 10 20 30 40 Static Pressure (psi) at Shower Valve 50 60 70 Valve Tub Port Flow Valve Shower Port Flow Shower Port Flow Through Diverter Finish Options Product Number 5438 Description Slide Bar, Showerhead and Valve. Two-handle thermostatic with integral ceramic disc diverter and temperature control. FBS - THERMOSTATS Polished Chrome 002 Satin Nickel (PVD) 295