Installation - Stanpro Lighting Systems
Transcription
Installation - Stanpro Lighting Systems
Installation Instructions / Notice de montage READ and UNDERSTAND these instructions before installing luminaire. AVERTISSEMENT LISEZ cette notice et assurez-vous de la COMPRENDRE avant de monter le luminaire. ELECTRICAL SHOCK HAZARD EN RISQUE D’ÉLECTROCUTION Disconnect the Electrical supply power at the services panel (fuse or circuit breaker box). Failure to do so could result in serious injury. FR WARNING Only qualified electricians should install this luminaire and the installation MUST conform to the Canadian Electrical Code Part I and any local codes and ordinances. Makes sure you have the proper tools and materials to complete the installation before attempting to install the luminaire. Couper l’alimentation du courant électrique au panneau de service (boîte de fusible ou disjoncteur) sans quoi il pourrait en résulter des blessures sérieuses. Seuls des électriciens qualifiés devraient installer ce luminaire et l’installation doit être conforme au Code Canadien de l’Électricité Première Partie ainsi qu’au codes et règlements locaux. Assurez-vous d’avoir les outils et le matériel nécessaires à l’installation avant d’essayer d’installer le luminaire. INSTALLATION 1 Remove product from carton 2 Loosen screw on rear lower casting and open the ballast door 3 Pull quick connect plug apart to allow removal of ballast door. 4 Loosen two 3/8” bolts with mast arm clamp to allow installer to slip the rear of the upper housing on the mast arm. 5 Tighten the fitter bolts while positioning the luminaire to be level with the roadway. ---DO NOT OVER TORQUE FITTER BOLTS--MAXIMUM – 72 INCH POUNDS 6 Re-install ballast door, connecting the quick connect plug 7 Open front housing and securely screw in correct wattage lamp 8 Install Photo Electric Control using dielectric grease 9 Turn on Power TROUBLESHOOTING CHECKLIST If Light Does Not Work: Check your power source. Check Electrical Connections. Check to insure proper seating of Lamp. Check if lamp burned out. IIS-COBRA-LARGE-R01