nf draagvermogen hangsteunen
Transcription
nf draagvermogen hangsteunen
DRAAGVERMOGEN HANGSTEUNEN I CAPACITE DE CHARGE DES PENDARTS Hangsteunen Pendarts Moment M (Nm) VSCL41.37 + MP3.41.41 MP + KPCL HDHSLECL HDHSLDCL VSCL41.60 + MP3.41.41 HSLE3 HDHSMU50 WKMP41.41 HDHSME HSMDCL x-as HSMDCL y-as HSMD HDHSIZ 85 90 130 380 400 400 430 475 480 1200 1400 1600 2150 Maximale belasting S (daN) Charge maximale S (daN) 700 300 1000 1800 1300 1000 2100 1700 1700 1700 1700 3500 2940 L F F L a M f a M f M=Fxa Getest volgens lEC 61537 Testé selon la norme IEC 61537. F = Belasting op de console a =Afstand van belasting tot de centerlijn van de hangsteun (m) L = Lengte hangsteun (m) M =Moment (daNm) = F x a f = Doorbuiging van de hangsteun (mm) Maximaal toegestane doorbuiging = U20 of 5% van de lengte F = Charge sur la console a = Distance entre charge et ligne centrale du pendart (m) L = Longueur du pendart (m) M = Moment (daNm) = F x a f = Déflexion du pendart (mm) Déflexion maximale autorisée = L/20 ou 5% de la longueur. MEERVOUDIGE BELASTING I CHARGES MULTIPLES F1 a1 M1 F2 a2 F3 M2 a3 M3 Ft = F1 + F2 + F3 Totale Belasting= som van alle belastingen Ft = F1 + F2 + F3 Charge totale = somme de toutes les charges Mt = (M1 + M3)- M2 = (F1 x a1 + F3 x a3) (F2 x a2) Mt = (M1 + M3) – M2 = (F1 x a1 + F3 x a3) – (F2 x a2) Totaal Moment = som van linksdraaiende Momenten - som van rechtsdraaiende Momenten Moment total = somme de tous les Moments tournants vers la gauche – somme de tous les Moments, tournants vers la droite M-of Moment-waarden, zie Er moet telkens aan volgende 2 voorwaarden worden voldaan: Les 2 conditions suivantes doivent toujours être respectées : Voorwaarde 1 · Totaal Moment (Mt) ≤ Max. Moment van de hangsteun (M- of Moment-waarden, zie tabel) Condition 1 : Moment Total (Mt) ≤ Moment max. du pendart (M- ou valeur Moment, voir tableau) en et Voorwaarde 2 ; Totale Belasting (Ft) ≤ Max. Belasting van de hangsteun (S-waarden, zie tabel) Condition 2 : Charge totale (Ft) ≤ Charge max. du pendart (Valeur S, voir tableau) Mt Ft Noot: Bij perfect symmetrische belasting: Mt = 0 In dat geval geldt enkel de tweede voorwaarde: Totale belasting (Ft) ≤ Max. Belasting van de hangsteun (S) Remarque : En cas de charge symétrique parfaite: Mt = 0 Dans ce cas, seulement la deuxième condition est valide : Charge Totale (Ft) ≤ Charge max. du pendart (S)