Mounting Suggestions: Suzuki 1400 Intruder 1987-04

Mounting Suggestions:
Suzuki 1400 Intruder 1987-04 &
S83 2005-09
One-Piece Seat
Baseplate Features:
The one-piece, marine-grade fiberglass baseplate is a
direct replacement for the stock two-piece seat. Rubber
bumpers are positioned to protect the frame and fender.
Stock Seat Removal Steps
1. Unplug the sissy bar pad.
2. Remove the tool kit.
3. Remove the rubber block inside the tool box.
4. Mounting screw will now be exposed; remove this mounting screw.
5. Slide passenger seat forward and up to remove.
6. Unbolt the two 10 mm bolts holding the solo to the fender.
7. Important: the electronics module is attached to the solo. Carefully lift solo off the
motorcycle.
8. Carefully remove the electronics module from solo.
Page 1 of 2
Mounting Suggestions: Suzuki 1400 Intruder 1987-04 & S83 2005-09 One-Piece Seat
Mounting of Mustang Seat
1. Bolt electronics module to baseplate of seat. See Fig. 1 & 2 for location.
2. Engage nose tab.
3. Secure to fender with stock bolt.
4. Reinstall rubber block, tool kit and sissy bar pad.
Fig. 1
Fig. 2
Enjoy the Comfort of your new Mustang Seat!
These steps are guidelines to help you install your new Mustang product. If you need further assistance,
please call us at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to
[email protected], or visit our website at www.mustangseats.com.
For care and maintenance of our seats, please go to our website under "Support".
Ref part #75248, 75261, 75265, 75879
Page 2 of 2