specimen - VeriSTAR

Commentaires

Transcription

specimen - VeriSTAR
Directive Navires de Plaisance
Recreational Craft Directive
Direction Marine
Marine Division
Page 1 of 2
Attestation/Certificate N°: 6633.0401.A0.9 CE-RCD
Dossier/File N°: BV ON 23-21
ATTESTATION DE CONFORMITE
STABILITE ET FRANC-BORD / FLOTTABILITE
ATTESTATION OF CONFORMITY
STABILITY AND FREEBOARD / BUOYANCY AND FLOTATION
Adresse/Address:
BRIG INFLATABLE BOATS
63
(&
Demandeur/Applicant:
,0
(1
Le soussigné, agissant dans le cadre de la notification du Bureau Veritas S.A., atteste que le type de bateau
identifié ci-après, est conforme aux exigences essentielles 3.2 (stabilité et franc-bord) et 3.3 (flottabilité) de
la Directive 94/25/CE transposée en droit national français par le Décret N° 96/611 du 4 Juillet 1996. / The
undersigned, acting within the scope of Bureau Veritas S.A.'s notification, certifies that the boat type
hereafter identified, complies with the essential requirements 3.2 (stability and freeboard) and 3.3
(buoyancy and flotation) of the Directive 94/25/CE transposed in the french national law by Decree Nr
96/611 of 4th July, 1996.
Takhiatashskaya 3, Kharkov, 310033 UKRAINE, CIS
Cette attestation n'est valide que pour le type de bateau mentionné ci-après / This certificate is valid only for
the boat type specified hereafter:
E 600
Cette attestation comporte une annexe de 1 page, qui décrit le type de bateau, les normes ou règles
appliquées, les plans et informations soumis, ainsi que les rapports d'essai réalisés. / This certificate is
accompanied by an annex of 1 page, describing the boat type, the standards or rules applied, the drawings
and informations submitted, as well as test reports done.
Etabli à / Issued at Paris La Défense le/on:
05/10/2000
Jean-Marc TABUTEAU
Responsable Plaisance
Yacht Manager
Cette attestation perd sa validité au cas où le bateau serait modifié par rapport au modèle examiné. Le constructeur doit informer le Bureau Veritas de toute modification ou
changement dans la conception du bateau pour obtenir une attestation valide. La dernière édition des Conditions Générales de la Direction Marine au verso, est applicable. / This
Certificate is not valid for boat, the design of which has been varied or modified from the specimen tested. The manufacturer shall inform Bureau Veritas of any modifications or
changes to the boat in order to obtain a valid certificate. The latest edition of the Marine Division General Conditions stated overleaf is applicable.
Directive Navires de Plaisance
Recreational Craft Directive
Page 2 of 2
Attestation/Certificate N°: 6633.0401.A0.9 CE-RCD
Dossier/File N°: BV ON 23-21
E 600 - BV ON 23-21
I. Type de bateau / Boat type:
Powered Inflatable Boat LHT= 6.15 m, B = 2.50 m
II. Plans et documents soumis pour examen / Drawings and documents submitted for examination:
Request for certification dd 12.09.2000
General data sheet
E 600 technical view
Airtightness test report
Inflatable compartments and hull compatments disposition
BV Odessa test report n° ODS/00/NS/042 dd 11 september 2000
HIN of tested hull: UA-BRG03825F001
,0
(1
III. Conformité au décret 96/611 du 4/7/96 (Annexe I)/Conformity to decree 96/611 of 4/7/96 (Annex I):
Point 3.2: Stabilité et Franc-Bord / Stability and freeboard: ISO DIS 6185-3 dd 01.04.2000
Point 3.3: Flottabilité / Buoyancy and flotability: ISO DIS 6185-3 dd 01.04.2000
63
(&
Design Category as per 94/25/CE
Length Overall (m)
Beam Overall (m)
Inboard Length (m)
Inboard Beam (m)
Max. Tube Diameter (m)
Number of Chambers
Maximum Number of Persons
Maximum Load (kg) (*)
Maximum Engine Power (kW)
Minimum Engine Power (kW)
C
6.15
2.5
4.3
1.4
.55
5
12
1500
120
-
B
6.15
2.5
4.3
1.4
.55
5
5
1000
120
75
(*) maximum load including engine(s) installed as per 6185-3 § 8.
Maximum manufacturer’s recommended load as per directive 94/25/CE annex I § 3.6 (excluding
engine) may therefore vary according to weight of engine installed.
IV. Conclusion:
The craft fulfills the technical requirements allowing conformity to essential requirements 3.2
(stability and freeboard) and 3.3 (buoyancy and flotation) of the Directive 94/25/CE . The following
informations will be indicated on the builder’s plate.
Design Category
B
C
Number of persons recommended by the builder
5
12
Maximum load recommended by the builder (kg) (**)
1270
770
CE 0062 (nota: No production survey performed)
(**) according to annex I § 3.6 of directive 94/25/CE - max. engine weight 230 kg. considered.
V. European Authorised Representatives of the builder:
-
SAKACO IMPORT Oy, Hannutie 2, 02300 ESPOO, Finland.

Documents pareils

specimen - Bureau Veritas

specimen - Bureau Veritas Certificate is not valid for boat, the design of which has been varied or modified from the specimen tested. The manufacturer shall inform Bureau Veritas of any modifications or changes to the boat...

Plus en détail