Philips Lighting Company - Achat

Philips Lighting Company
Lamp Material Data Sheet (LMDS)
LMDS #: CFN – 10001A
Date: 03/15/2011
Product: Philips Compact Fluorescent Lamps CFL-ni – All Types
ALTO and non-ALTO: PL-C, PL-H, PL-L, PL-Q, PL-S, PL-T
Page 1 of 2
Section 1. Manufacturer and Contact Information
Philips Lighting Company
Division of Philips Electronics North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873-4186
24 HR Emergency Phone Number:
Other Information Calls:
(800) 424-9300 CHEMTREC
(800) 555-0050 Philips Lighting Technical Information
Section 2. Hazardous Ingredients/Identity Information
These lamps may contain the following materials:
Material
Inert Materials (glass/metals)
Phosphor Powder
(as Nuisance Dust)
Yttrium Oxide (as Yttrium)
Barium Magnesium Aluminate
Cerium Magnesium Aluminate
Indium
Bismuth
Mercury
Isotope (Kr85 or H3)
(CAS #)
Exposure Limits in Air
OSHA PEL
(1314-36-9)
(63774-55-0)
(67542-72-7)
(7740-74-6)
(7440-69-9)
(7439-97-6)
(713983-27-2/10028-17-8)
mg/m3
15
1
n/a
n/a
0.1
0.1
0.1
-
ACGIH TLV
mg/m3
10
1
n/a
10
0.1
n/a
0.025
-
PERCENTAGE
by weight
~98.0%
<2.0%
<0.5%
<0.1%
<0.1%
<0.15%
<0.15%
<0.025%
<100ηCi
The Phosphor Powder materials are ceramic phosphors. The ceramics are Cerium/Barium Aluminate and Yttrium Oxide.
The PEL and TLV are given where available for the base materials. There is no data for the ceramics as mixtures.
Section 3. Physical Properties
Not applicable to an intact lamp. These items are light bulbs in various shapes, configurations, and designs. All contain
small glass fluorescent tubes, a plastic housing, and various pin-style bases for use in specific fixtures/sockets. Some
lamps may contain isotopes (nanoCurie quantities) to aid in lamp starting - Product packaging is appropriately labeled.
Section 4. Fire and Explosion Hazards
Not applicable to an intact lamp. If subjected to extreme heat, the plastic and glass components of the lamp may crack
or melt and the lamp may emit toxic fumes.
Philips Lighting Company
200 Franklin Square Drive
Somerset, NJ 08873-4186
Tel: 732.563.3000
A Division of
Philips Electronics North American Corporation
Section 5. Reactivity
Not applicable to an intact lamp.
Section 6. Health Hazards
Not applicable to an intact lamp. Breakage of the lamp may result in some exposure to the phosphor powder and to
elemental mercury. No adverse effects are expected from occasional exposure to broken lamps, but as a matter of good
practice, prolonged exposure should be avoided through the use of adequate ventilation during the disposal of large
quantities of lamps.
Emergency and First Aid Procedures: Apply normal first aid for glass cuts if such should occur through lamp breakage.
Section 7. Lamp Disposal Procedures
Normal precautions should be taken for the collection of glass particles in the event a lamp is broken.
Waste Disposal Method: All compact fluorescent lamps contain some amount of mercury. When a compact fluorescent
lamp is to be disposed, it is subject to the current EPA Toxicity Characteristic Leaching Procedure (TCLP) disposal
criteria. This test is used to determine if an item can be managed of as hazardous or non-hazardous waste.
Philips low-mercury ALTO compact fluorescent lamps are identifiable by their characteristic green logo. Philips ALTO
lamps are TCLP compliant and can be managed as non-hazardous waste. Philips will provide TCLP test data upon
request.
Philips non-ALTO lamps (with black logo) are not TCLP compliant and should be managed as a hazardous waste under
the EPA Universal Waste Rules for fluorescent lamps.
All disposal options should be evaluated with respect to federal, state, and local requirements. Before disposing of waste
lamps, check with federal, state, and/or local officials for current guidelines and regulations. Philips encourages recycling
of its products through qualified recycling facilities.
Section 8. Control Measures
Respiratory Protection: None. NIOSH-approved respirator should be used if large quantities of lamps are being broken
for disposal.
Ventilation: Avoid inhalation of any airborne dust. Provide local exhaust when disposing of large quantities of lamps.
Hand and Eye Protection: Appropriate hand and eye protection should be worn when disposing of lamps and/or handling
broken glass.
Section 9. Regulatory Information
As a product, these mercury-containing lamps, when shipped in the manufacturer’s original packaging, are not regulated
by air, truck, or ocean shipment. As a waste, these lamps may be regulated in various states and local communities.
This safety data sheet does not constitute “knowledge of the waste” in certain jurisdictions.
This document supercedes previous document: LMDS CFN-10001, last revised 07/30/2010
Occupational Health and Safety Administration (OSHA) Material Safety Data Sheet (MSDS) requirements for materials
are not applicable to manufactured articles in which individuals would not be subjected to materials contained in the article
during its normally intended use. The information in this document is provided as a courtesy and is intended to provide
relevant information in the event the articles it covers are encountered during unintended, or abnormal, circumstances.
MASTER PL-T 4 Broches
MASTER PL-T 42W/840/4P 1CT
Lampe fluocompacte à alimentation séparée Nouvelle base
miniaturisée Lampe à 6 tubes parrallèles
Données du produit
• Caractéristiques Générales
Culot
Information culot
Durée de vie moy B.
cat chaude
Durée de vie moy B.
cat froide
EL sans prech. (10%
de mort)
Durée de vie EL CC
(10% mort)
LSF HF Preheat
12000h Rated,3h
LSF HF Preheat
8000h Rated,3h
LSF HF Preheat
6000h Rated,3h
LSF HF Preheat
4000h Rated,3h
LSF HF Preheat
2000h Rated,3h
GX24q-4
4P
13000 hr
7000 hr
4500 hr
8000 hr
60 %
90 %
97 %
98 %
99 %
• Caractéritiques techn. de lumière
Code couleur
Indice de rendu des
couleurs
Désignation teinte
Température de
couleur
Coordonnée chromatique X
Coordonnée chromatique Y
Eff Lum sur ball HF à
25°C
840 [CCT of 4000K]
82 Ra8
Blanc brillant
4000 K
380 379 74 (min) Lm/W
LLMF HF 12000h
Rated
LLMF HF 8000h
Rated
LLMF HF 6000h
Rated
LLMF HF 4000h
Rated
LLMF HF 2000h
Rated
Luminous Flux EL
25°C, Rated
Luminous Flux EL
25°C, Nominal
Design Temperature
81 %
84 %
86 %
88 %
92 %
3050 Lm
3200 Lm
28 C
• Caractéristiques électriques
Puissance lampe
Tension lampe ballast
EL 25 °C
Courant lampe,
ballast EL 25°
Gradable
Lamp Wattage EL
25°C, Rated
Puiss. nom. lampe EL
à 25°C
42 W
125 V
0.320 A
Oui
41.0 W
42 W
• Caractéristiques environnementales
Label d'efficacité
energétique
Contient du mercure
B
1.4 mg
MASTER PL-T 4 Broches
• Conditions de mesure
Calibration Current
HF Generator Rated
Voltage
Resistor
0.320 A
270 V
420 ohm
• Dimensions en mm.
Longeur culot - culot
A
Longueur insertion B
Longeur totale C
Diamètre ampoule D
120.7 (max) mm
145.0 (max) mm
160.7 (max) mm
41.0 (max) mm
Code produit EOC
Nom produit
Désignation
Pièces par pack
Config. Emballage
Packs par carton
Code barre produit
EAN 2
Code barre carton
regroup.
Code usine
Code ILCOS
Poids net unitaire
871150061137670
MASTER PL-T 42W/840/4P 1CT
MASTER PL-T 42W/840/4P 1CT/
5X10CC
1
5X10CC
50
8711500611376
8711500611383
8711500611390
927914884071
FSMH-42/40/1B-L/P-GX24q=4
83.000 gr
• Données produit
Code commercial
611376 70
Mises en garde et sécurité
• Shorter lamp life when often switching and not well pre-heated
electrodes
• Lamp light technical and electrical characteristics are influenced by
operating conditions, i.e. lamp ambient temperature and operating
position as well as applied HF control gear
Schéma dimensionnel
GX24q-4, 4P
D
Product
A (Max) B (Max) C (Max) D (Max)
145.0
160.7
41.0
C
B
A
PL-T 42W/840/4P M 120.7
24
GX24q-4
2011, décembre 21
Les données sont sujettes à changement
MASTER PL-T 4 Broches
W per 5 nm per lm
µW per 5 nm per
Données photométriques
500
400
300
500
400
300
200
200
100
100
300
400
500
600
700
l nm
300
400
Lightcolor /840
500
600
700
λ nm
Lightcolor /840
© 2011 Koninklijke Philips Electronics N.V.
Tous droits réservés.
Les données sont sujettes à changement sans préavis. Les noms et marques sont la propriété de
Koninklijke Philips Electronics N.V. ou de leurs ayants droits respectifs.
www.philips.com/lighting
2011, décembre 21
Les données sont sujettes à changement