GEMINI 5079
Transcription
GEMINI 5079
GEMINI 5079 No forest has been destroyed to produce this 100% recycled paper. by GEMINI TRADING S.r.l. Via Luigi Galvani 12 21020 Bodio Lomnago (VA) Italia Tel. +39 0332 943211 - Fax +39 0332 948080 INTODUCTION GEMINI 5079 Gemini 5079 is an immobilizer that can be installed on cars with 12 or 24 volts battery (negative ground). DESCRIPTION -It can work at 12 or 24 volts automatically -It has 2 engine immobilisations with 30 A relais. -Automatic arming. SELF LEARNI G OF A NEW CODE. 1. 2. 3. 4. Switch off the system Connect the black wire initialled HW to the earth of the car Switch ON and OFF the dashboard with the car’s key Transmit a new code to be learned inserting a key in the receptacle. If the code is learned, the LED will signal with a flash. Repeat the point 3 and 4 for each learning operation. If the immobilizer is connected with an alrm repeat the point and push on the tranmitter’s button, if the code is le arned the LED will signal it with a flash. 5. At the end of the procedure disconnect and isolate the wire HW -Disarming trought randomic electronic key (art. CDE 2). -It can works together with 7000 Gemini line. The unit is supplied with 2 electronic keys (art. CDE 2). WIRING CONNECTIONS (DISCONNECT THE NEGATIVE TERMINAL OF THE BATTERY AND ONLY RE- CONNECT AFTER THE INSTALLATION IS COMPLETED ) ð BLACK initialled M Earth ð BLACK initialled R Battery positive terminal ð 2 BLACK wires initialled B Immobilisation relay 1 ð 2 BLACK wires initialled H Immobilisation relay 2 ð BLACK initialled G Ignition live ð BLACK initialled VM Door pin switch ð BLACK initialled HW Wire for self learning NOTE:Connect: - the BLACK femele MODU II connector to the jack of the key - the BLACK mascule MODU II connector to the Led of the key’s jack - the YELLOW mascule MODU II connector to the jack coming from the alarm unit (to be used only together with an alarm unit). NOTE THIS PROCEDURE WORKS ONLY WITH THE IMMOBILIZER IN OFF CONDITION . IT IS POSSIBLE TO LEARN A MAXIMUM OF 4 KEYS, EACH FOLLOWING LEARNING WILL DELETE ONE OF THE PREVIOUS KEY ALREADY LEARNED. TECHNICAL DATA Power supply 12-24 VDC Current drawn 2 mA Working temperature -30°C +85°C Engine immobilisation relay contact capability 30 A Protection degree mechanic closure IP40 Memorizable codes 4 ARMING. The 5079 is automatically armed: - 5 minutes later the engine is switched off if any door is opened. - 1 minute later the engine is switched off if one door is opened. When the system is ON the LED starts to flash and it is impossible to start the car. DISARMING. To disarm the system it is necessary to insert the electronic key (art. KIT CDE2) into the receptacle; if the code is right the LED will flash and it is possible to start the engine. The manufacturer declines every responsibility for any possible defect or failure to the device and to the vehicle’s electric system due to incorrect installation or to the alteration of the indicated Technical Features. The alarm system has only a dissuasive function against possible thefts. This device is guaranteed against construction or working faults for 12 months from purchase date and for a maximum of 24 months from manufacturing date. DIAGRAM ART.5079GE. 5079 BLACK initialled M BLACK initialled R EARTH + Battery 12 VOLT BLACK initialled GM +30 BLACK initialled G Door pin switch Led Key positive Electronic Key CDE2 Electronic key socket with LED BLACK initialled B 30A MAX ! BLACK initialled B STARTER +50 Immobilisation Relais N.1 BLACK initialled H Black Black Black Black Yellow connectors Black Black To the remote controlled alarm ( 7000 series ) BLACK initialled H 30A MAX ! Immobilisation Relais N.2 BLACK initialled HW