SETTING UP the Sun StorEdgeTM 5210 NAS

SETTING UP the Sun StorEdge 5210 NAS
TM
Power
Cord
POWERUP
CONTENTS
NOTE: Always power on the units in the following order:
1. Expansion Storage Modules (JBOD) first.
2. Sun StorEdgeTM 5210 NAS Filer.
FRONT PANEL
1. Power on the JBOD (if present) power switches and allow the
hard drives to spin up for a minute. If you do not have a JBOD,
skip to the next step.
Sun StorEdge 5210 NAS
Hard Drive Status LED
Power LED
Front "ears"
Front view
System Status LED
System ID LED
2. Turn on the Sun StorEdge 5210 NAS by pressing its power
switch.
NIC 1 LED
Front Bezel
NIC 2 LED
System ID
Button
Power Button
If DHCP is used, the IP address is automatically configured.
Skip Network Setup without DHCP and go to System
Configuration.
Reset
Button
Warning:
CD
Set up poster
NETWORK SETUP without DHCP
NMI (Not Used)
The X5030A slide rail kit is required to
safely mount this unit. The kit is sold
separately.
LEDs and Pushbuttons
1. Press the Select button once, then select Set Static IP.
Detailed installation instructions are
included with the kit.
2. Enter or accept the values listed below, then move the cursor to the
far right to save them:
Up
Using a kit other than the X5030A could
create a safety hazard or damage the
system or cabinet.
The front "ears" hold the bezel. Do not
use them for rack mounting.
If your network does not support DHCP, follow these steps to manually
configure the IP address using the LCD Panel Controls:
Exit
LED display
Select
*
*
*
*
IP Address
Subnet mask
Broadcast Address
Gateway Address (if necessary)
Down
SYSTEM CONFIGURATION
Rear view
LED Panel Controls
Using a separate system with a Java-enabled browser connected to
the network:
1. Make sure the network link LED is green.
2. Enter the 5210's IP address.
POWER
NOTE: You must use a Java-enabled browser. If not already installed,
the Configuration Wizard prompts you to allow your browser to
install the Java Plug-in from the Internet. Click Yes.
CABLING
POWER
A
1
After installing the Java Plug-in, it takes about 45 seconds for the
Login page to load. If you have trouble connecting, try enabling
the browser option to bypass the proxy server for local addresses.
2
3. Click Apply to log in. (no passwords are required at this point). The
system displays the End-User agreement.
B
4. Click Accept Agreement to continue. The system prompts you to
start the Configuration Wizard.
RJ45 Serial UPS Control
RJ45 NIC 1
RJ45 NIC 2
Power connector #1 powers module A
Power connector #2 powers module B
5. Click Next to start the Configuration Wizard.
6. Follow the steps in the Configuration Wizard to complete the
system setup.
Copyright © 2004 Sun Microsystems, Inc., 4150 Network Circle, Santa Clara, California 95054 U.S.A. All rights reserved. Sun Microsystems, Inc. has intellectual property rights relating to technology embodied in the product that is described in this document. In particular, and without limitation, these intellectual property rights may include one or more of the U.S. patents listed at http://www.sun.com/patents and one or more additional patents or pending patent applications
in the U.S. and other countries. This document and the product to which it pertains are distributed under licenses restricting their use, copying, distribution and decompilation. No part of the product or of this document may be reproduced in any form by any means without prior written authorization of Sun and its licensors, if any. Third-party software, including font technology, is copyrighted and licensed from Sun suppliers. Sun, Sun Microsystems, the Sun Logo, Sun Cobalt, the Sun
Cobalt Logo, Sun Cobalt RaQ, Java and JDK are trademarks or registered trademarks of Sun Microsystems, Inc. in the United States and other countries. UNIX is a registered trademark in the United States and other countries, exclusively licensed through X/Open Company, Ltd. Netscape and Netscape Navigator are trademarks or registered trademarks of Netscape Communication Corporation in the United States and other countries. Legato NetWorker is a registered trademark
of Legato Systems, Inc. Federal Acquisitions: Commercial Software -- Government Users Subject to Standard License Terms and Conditions. DOCUMENTATION IS PROVIDED “AS IS” AND ALL EXPRESS OR IMPLIED CONDITIONS, REPRESENTATIONS AND WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-INFRINGEMENT, ARE DISCLAIMED, EXCEPT TO THE EXTENT THAT SUCH
DISCLAIMERS ARE HELD TO BE LEGALLY INVALID.
Part Number / Numéro de pièce:
817-7430-12
Date: 10-2004
Copyright © 2004 Sun Microsystems, Inc., 4150 Network Circle, Santa Clara, California 95054 États-Unis. Tous droits réservés. Sun Microsystems, Inc. détient des droits de propriété intellectuelle sur la technologie réunie dans le produit qui est décrit par ce document. Ces droits de propriété intellectuelle peuvent s’appliquer en particulier, sans toutefois s’y limiter, à un ou plusieurs des brevets américains répertoriés à l’adresse http://www.sun.com/patents et à un ou plusieurs
brevets supplémentaires ou brevets en instance aux Etats-Unis et dans d’autres pays. Ce produit ou document est protégé par un copyright et distribué avec des licences qui en restreignent l'utilisation, la copie, la distribution et la décompilation. Aucune partie de ce produit ou document ne peut être reproduite sous aucune forme, par quelque moyen que ce soit, sans l'autorisation préalable et écrite de Sun et de ses bailleurs de licence, s'il y en a. Le logiciel détenu par des tiers, et qui
comprend la technologie relative aux polices de caractères, est protégé par un copyright et licencié par des fournisseurs de Sun. Sun, Sun Microsystems, le logo Sun, Sun Cobalt, le logo Sun Cobalt, Sun Cobalt RaQ, Java et JDK sont des marques de fabrique ou des marques déposées de Sun Microsystems, Inc. aux Etats-Unis et dans d’autres pays. UNIX est une marque déposée aux Etats-Unis et dans d'autres pays et licenciée exclusivement par X/Open Company, Ltd. Netscape
et Netscape Navigator sont des marques de fabrique ou des marques déposées de Netscape Communication Corporation aux Etats-Unis et dans d’autres pays. Legato NetWorker est une marque déposée de Legato Systems, Inc. LA DOCUMENTATION EST FOURNIE “EN L’ETAT” ET TOUTES AUTRES CONDITIONS, DECLARATIONS ET GARANTIES EXPRESSES OU TACITES SONT FORMELLEMENT EXCLUES, DANS LA MESURE AUTORISEE PAR LA LOI APPLICABLE, Y COMPRIS
NOTAMMENT TOUTE GARANTIE IMPLICITE RELATIVE A LA QUALITE MARCHANDE, A L’APTITUDE A UNE UTILISATION PARTICULIERE OU A L’ABSENCE DE CONTREFAÇON.