IC-CB IC-CB - NextCentury
Transcription
IC-CB IC-CB - NextCentury
IC-CB IC-CB TECHNICAL ACCEPTANCE CERTIFICATE NO: AN16I6566 ISSUED UNDER THE AUTHORITY OF THE CERTIFICATION AND ENGINEERING BUREAU OF INDUSTRY CANADA CERTIFICATION NO CERTIFICATION PROCEDURE CERTIFICATE HOLDER TYPE OF EQUIPMENT TRADE NAME AND MODEL RADIO APPARATUS CATEGORY FREQUENCY RANGE (MHz) 910.2 to 920 20949-TR20214 SINGLE CERTIFICATION NEXT CENTURY SUBMETERING SYSTEMS, LLC PO BOX 360, TYBEE ISLAND , GA 31328 , USA TRANSCEIVER TR-201 SPREAD SPECTRUM DEVICE (902-928 MHZ) EMISSION DESIGNATOR 37K8G1D R.F. POWER (Watts) 0.088 SPECIFICATION / ISSUE RSS-247 1 / MAY 2015 ANTENNA TYPE ANTENNA GAIN (dBi) ANTENNA CONNECTOR PCB 1.25 Output power listed is conducted. This device must be installed to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter except in accordance with IC multi-transmitter product procedures. End-Users must be provided with transmitter operation conditions for satisfying RF exposure compliance. MEASUREMENT FACILITIES LABORATORY NAME IC OATS LISTING UL VERIFICATION SERVICES INC IC OATS NUMBER: 2324B-1 47173 BENICIA ST,FREMONT,CA USA TEL: 5107711029 FAX: (510) 661-0888 EMAIL: [email protected] Certification of equipment means only that the equipment has met the requirements of the above-noted specification. Licence applications, where applicable to use certified equipment, are acted on accordingly by the Industry Canada issuing office and will depend on the existing radio environment, service and location of operation. This certificate is issued on condition that the holder complies and will continue to comply with the requirements and procedures issued by Industry Canada. The equipment for which this certificate is issued shall not be manufactured, imported, distributed, leased, offered for sale or sold unless the equipment complies with the applicable technical specifications and procedures issued by Industry Canada. La certification du matériel signifie seulement que le matériel a satisfait aux exigences de la norme indiquée ci-dessus. Les demandes de licences nécessaires pour l’utilisation du matériel certifié sont traitées en conséquence par le bureau de délivrance d’Industrie Canada et dépendent des conditions radio ambiantes, du service et de l’emplacement d’exploitation. Le présent certificat est délivré à la condition que le titulaire satisfasse et continue de satisfaire aux exigences et aux procédures d’Industrie Canada. Le matériel à l'égard duquel le présent certificat est délivré ne doit pas être fabriqué, importé, distribué, loué, mis en vente ou vendu à moins d'être conforme aux procédures et aux spécifications techniques applicables publiées par Industrie Canada. I hereby attest that the subject equipment was tested and found in compliance with the above-noted specification. J'atteste par la présente que le matériel a fait l'objet d'essai et jugé conforme à la spécification ci-dessus. ISSUED BY: Bob Delisi / Certification Engineer, UL Verification Services Inc. ISSUED ON: February 22, 2016 Page 1 of 1 UL Verification Services Inc. 47173 Benicia Street, Fremont, CA 94538 Tel: (510) 771-1000, Fax: (510) 661-0888, Http://www.UL.com Document No: CCSUC4410 Rev. B