JMB390 Controller 2-port RAID Card install Guide

JMB390 Controller 2-port RAID Card install Guide
Set the RAID mode, you need to install the 2-port storage device, otherwise it is impossible
to set the RAID mode.
The D1 LED green light has been lit, indicates that the power supply is normal, when read
or write, flashes.
The D2 LED red light has been lit, it indicates an error, neither installed at the same time the
two storage.
When changing the RAID mode or Clear mode, D2 LED red light flickering, change is
complete.
step 1.
Restore RAID initial value
SW1 Config
Config
1
2
3
RAID 1
OFF
ON
ON
RAID 0
ON
ON
ON
JBOD
ON
OFF
ON
Clear
OFF
OFF
ON
Clear
OFF
OFF
ON
step 2.
Set the RAID 1 mode:
Any RAID mode change, are required to restore the RAID initial value (Clear SW below),
reboot.
After reboot, BIOS appear state (device 1 data), and then shut down
Set RAID 1 mode (RAID 1 SW below), then reboot
When the reboot, the BIOS will show RAID mode (JMicron H/W RAID 1) to complete the
set
Clear SW:
Clear
RAID 1 SW:
OFF
OFF
ON
RAID 1
OFF
ON
ON
step 3.
Set the RAID 0 mode:
Any RAID mode change, are required to restore the RAID initial value (Clear SW below),
reboot.
After reboot, BIOS appear state (device 1 data), and then shut down
Set RAID 0 mode (RAID 0 SW below), then reboot
When the reboot, the BIOS will show RAID mode (JMicron H/W RAID 0) to complete the
set
Clear SW:
Clear
RAID 0 SW:
OFF
OFF
ON
RAID 0
ON
ON
ON
step 4.
Set the RAID 0 mode:
Any RAID mode change, are required to restore the RAID initial value (Clear SW below),
reboot.
After reboot, BIOS appear state (device 1 data), and then shut down
Set RAID JBOD mode (JBOD 0 SW below), then reboot
When the reboot, the BIOS will show RAID mode (JMicron H/W LARGE) to complete the
set
Clear SW:
Clear
JBOD SW:
OFF
OFF
ON
JBOD
ON
OFF
ON
Tip:
1. RAID Card is SATA II, 3Gb/s interface.
2. Implementation of a maximum speed of 300GB/s
3. Prevention RAID MODE lost, SW3 After completing the settings, switch to the OFF