2D - Nicomatic
Transcription
2D - Nicomatic
A B C D CARACTERISTIQUE TECHNIQUES 0,2 1,7 12,8 2,59 0,85 Lenght on support 6 1 4 0,85 CARATERISTIQUES MECANIQUES Résistance à l’arrachement d’un contact sur circuit 15 N mini dans le sens perpendiculaire à la piste (rupture du conducteur) 50 N mini dans le sens de la piste (rupture du conducteur) 1,51 CARATERISTIQUES ELECTRIQUES Résistance de contact 5 mΩ maxi Résistance de contact après essais climatique 6 mΩ maxi Résistance d’isolement 5.105 MΩ à 500 V Tension de tenue 1100 V eff. Capacité entre deux contacts 4pF maxi Intensité nominale par contact en courant continu 3 A permanent Intensité nominale par contact en courant alternatif 5 A permanent 0,7 3,21 21,9 3 19,3 After Cutting 4 MATERIAU Bronze phosphoreux PROTECTION DES TERMINAISONS MÂLES Le contact standard est étamé (épaisseur : Ni 1 à 2µ mini + Sn pur brillant 3 à 5µ) Contact doré (épaisseur : Ni 1 à 2µ mini + Sn pur brillant 3 à 5µ + Au 0.15µ) 3D view Scale 4:1 1,3 0,63 3 CARACTERISTIQUES THERMIQUES Température de tenue des connecteurs -55°C à +150°C -67°F to +302°F 0,63 Cutting 2 1,6 Winding position after treatment 1,25 1 ép: 0,2 2,54 3D view Scale 1:2 Code Bobine Code X Type de bobine 1 Bobine incompléte 2 Bobine compléte 2 11/12/12 1 Type de traitement de surface Etamé= Ni 1 à 2µ + Sn pur brillant 3 à 5µ Etamé/Doré selectif= Ni 1 à 2µ + Sn pur brillant 3 à 5µ + Au 0,15µ This document and drawings, sketches, and schematic drawings are the property of the NICOMATIC company. and no parts thereof may be reproduced and used without the written consent of the owner. Law dated 11.03.1902 D Coil made of 35 000 contacts Marking as referenced in the CMM catalogue pages 11 & 13 Code traitement de surface Code Y 1 3 2 Identification Label Catalogue Reference : www.nicomatic.com Mail : [email protected] Tel : +33 (0)4.50.36.13.85 Iss Date C.B. Drawn A.V. Approved Checked Item : Contact Crimplex male square 1 Folder : X:\Méthodes\Plans clients\Plans clients 2D\01 - Crimpflex\01 - Terminaison mâle\13756-YX_cl 13756-YX General tolerance ±0.2 A4 Scale 5:1 Page 1/1