OPEL TIGRA
Transcription
OPEL TIGRA
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00 www.cobra.it MAKE OPEL MOD. TIGRA YEAR 95 → PETROL DIESEL X ALARM/SIREN POSITION Position the compact alarms and the sirens on the bracket located near the left side of the shock absorber. POWER SUPPLY + 30: connect to the 4 mm RED wire with GREEN tally mark located in the connector behind the fuse box. - 31: connect to the general supply wiring fastened to the car body, near the output of the drivers side door. IGNITION WIRE Connect to the wire marked + 15 located on the ignition key. DIRECTION INDICATORS Connect to the BLACK/GREEN and BLACK/WHITE wires located in the connector marked A3, behind the left lateral side. ELECTRIC WINDOWS For vehicles provided with windows automatism: - refer to diagram nr. 9 for no driven Bridge serie antithefts (art. 5933, 3100 with BROWN wire) - refer to diagram nr. 111 for driven Bridge serie antithefts (with BROWN/WHITE wire). CENTRAL DOORS LOCKING Negative control signal Connect to the BROWN/RED wire (lock) and BROWN/WHITE wire (unlock) located in the wiring harness coming out of the drivers side door. IMMOBILISATION POINT 1 Relay control signal 2 Cut the 1 mm BLACK wire located in the connector of the black relay behind the passengers side. IMMOBILISATION POINT 2 Pump control signal Cut the RED/BLUE wire located in the connector corresponding to the fuse marked F1 in the fuse box, otherwise behind the bulkhead on the left lateral drivers side. BONNET SWITCH Install an additional switch on the bonnet bumper near the shock absorber, drivers side. DOORS SWITCH Connect to the GREY wire located in the wiring harness coming out of the driver’s side door. BOOT SWITCH Connect to the GREY/BLACK wire located directly on the boot lamp. 2 Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed as per the instructions given on the product installation manual. optig95gbb.doc SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00 www.cobra.it FITTING DIAGRAM N° 9 Brown +30 1055 Fuse 1 Push button left window 2 3 4 5 6 7 Push button right window DIODE 1N4004 Grey/Green left Grey/Green right Connector coming out the driver’s side door NOTE: the windows central unit will reset if it is made a connection between passenger’s compartment and door or driving is left for any reason. In order to make a new reprogramming it is enough to operate the window raise for about 5” (when the window is completely closed). Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed as per the instructions given on the product installation manual. optig95gbb.doc SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00 www.cobra.it FITTING DIAGRAM N° 111 Diagram to make the electric windows locking on OPEL CORSA – TIGRA with automatism (for Bridge serie antithefts) Bridge serie antitheft (autodriven serie ) +30 1052 1 2 3 4 5 BROWN/WHITE (Temporized to 24s) Diodes 1N4004 Left window Right window switch switch GREY/GREEN M GREY/GREEN Original switches Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed as per the instructions given on the product installation manual. optig95gbb.doc