NOMA® BEAM Touch
Transcription
NOMA® BEAM Touch
NOMA® BEAM Touch-up paint Colour Yellow or dark brown pH-Value 8,3 ± 0,2 Product: Touch-up paint for beams Article codes: DZBTTE1 & DZBTTE2 Characteristics: Easy to apply; Flexible; Can be cleaned with water; Meets RoHs requirements. Applications: Touch-up paint for beams, designed to help hide scratches, grazes, glue joints, putty joints and other blemishes. Packaging: 50 ml bottles Certificate Certificate of of approval approval no 953115 n° 953115 Storage conditions and duration: Approximately 1 year in original packaging, at an ambient temperature of 20 to 25°C. Protect against frost. After opening, the product must be used up quickly. See packaging for best before date. w w w. n m c . e u NMC sa sa NMC Gert-Noël-Strasse Gert-Noël-Straße B-4731 Raeren/Eynatten B-4731 Eynatten NMC sa se réserve le droit de modifier à tout moment et sans avis préalable les caractéristiques et la gamme de ses produits. Les informations contenues dans ce prospectus sont données sur base de bonne foi et en rapport avec les connaissances techniques actuelles. L’application correcte incombe à l’usager. Si ce dernier hésite quant à l’application requise, NMC sa l’invite à s’informer auprés de la société ou de ses représentants. NMC sa Gert-Noël-Straße ‑ B-4731 Eynatten ‑ Belgien Tel.: +32 87 85 85 00 Fax: +32 87 85 85 11 E-Mail: [email protected] 2 NOMA® BEAM Touch-up paint Substrates: NMC polyurethane beams Instructions for use: The most important stages for a successful application are the cleaning and the pre-treatment. The surface to be painted must be clean, dry and free of grease, oil or other contaminants. Paint ready to use, also for spraying, shake before use. A lighter colour can be obtained by diluting with water (1-5% by weight). Do not allow to become too pale. If electrostatic pistols are used to vaporise the paint, such appliances must be protected against water. Drying times (at 30°C): Touch dry: 45 - 60 min Ready for use: 1.5 – 2 hours Completely dry: after 72 hours Safety measures: Observe the usual Occupational Health & Safety procedures; Follow the instructions on the labelling; Refer to the safety sheet for more detailed information. Notes: Clean with hot water. Water can always be used for an initial cleaning. If a stronger detergent is required, solvent-free products can be used for a second cleaning (ethyl acetate). Without a written agreement to the contrary, our studies, descriptions, notices, advice or other technical documents concerning the functionality, behaviour or performance of goods are supplied as an indication only according to the common use of the goods under normal conditions of application, use and climate (temperate European regions), or those indicated to us by customers in writing. Save for the existence of fraud or gross negligence on our part, these studies, recommendations and other technical documents do not engage our liability. It is the customer’s responsibility to check that they are suitable for the intended use. 03-2010 NMC sa / 2010 Éditeur responsable: NMC sa, Gert-Noël-Straße, B-4731 Eynatten