Data Sheet - GH International
Transcription
Data Sheet - GH International
031 LEAK STOPPER RUBBERIZED ROOF PATCH Data Sheet TYPICAL PHYSICAL & PERFORMANCE CHARACTERISTICS • Stops roof leaks instantly • Specially designed for problem leaks • Lasts 2-3x longer than other patches • Fiber reinforced • Trowel grade • Flexes to prevent cracking • Highest penetrating repair DESCRIPTION: Leak Stopper is a revolutionary advancement in roof patching and repair. This long lasting rubberized repair is specially formulated to penetrate deep into damaged areas and stop roof leaks instantly! The secret is Penetrex™, a unique penetrating oil that reaches deep into the crack and forms a complete seal. With the addition of liquid rubber, this flexible, high performance plastic cement provides a superior watertight bond that will stop problem leaks for good. Weight Per Gallon, lbs. 8.2-8.7 lbs. Residue by Evaporation, % 80 min. Flexibility Good. Stretches to resist cracks Combustible Solvents Mineral Spirits Consistency Trowel Cure Time (at recommended coverage rate) 4-8 hrs to set - 24-48 hrs to cure depending on surface & weather Application Temperature 50°-120°F Flammability (Flash pt. °F solvent) 105° Clean-up Tools Paint thinner, mineral spirits WHAT IT DOES: Stops roof leaks instantly. WHAT IS NEEDED TO COMPLETE THE JOB? Trowel or caulk gun, gloves and reinforcing fabric. PREP THE AREA: Surfaces must be clean, free of surface rust and loose material. HOW TO APPLY: Use trowel to spread across damaged surface of roof. Embed reinforcing fabric after first layer and apply second layer on top of fabric. Approx. Shipping Weights: (Note: All approx. weights include container.) 1 gallon (3.8L) 9 lbs. (6) 1 gallon containers/case 54 lbs. 3 gallons (11.4L) 27 lbs. 55 gallons (18.9L) 44 lbs. HOW MUCH DO I NEED? Covers approximately 8 sq. ft. per gallon. DO's and DON'Ts: Do apply in exterior applications only. Do wear protective clothing. Don't apply to plastic, EPDM, Hypalon or similar type of synthetic rubber roof system. If there is a question on compatibility, test a small section first before application to entire surface area. FOR BEST RESULTS: It is highly recommended to reinforce the repair with a strip of reinforcing fabric. Work material to an even consistency over and into the area to be repaired approximately 1/8" to 1/2" thick, two or three inches beyond the problem area. Embed fabric into the cement and cover with a second layer of cement. Form a feathered edge with cement where chimney's, vent pipes, and other projections meet the roof line. DO NOT EXPOSE DIRECT HEAT/FLAMES OR THIN. Best used when surface temperatures are between 50° and 120° F. In colder weather (50° and below), product should be stored in heated room (70° to 80° F.) at least 24 hours prior to application to promote ease of application. Product formulated to be used year round. PRECAUTIONS: Protective clothing and eye wear should be used during application of these products. When transporting this product, ensure that lid is tight and pail secure and upright. Do not allow pail to tumble as this may cause lid to loosen and leakage to occur. Do not transport on passenger seats or inside the passenger compartment of any vehicle. Store product in the cargo area of vehicle, and secure over protective cloths to prevent damage due to accidental spills. Do not store at temperatures above 100° F. This manufacturer also disclaims liability for flat surface application where poor drainage or ponding water may prevail. Do not reuse empty containers. HOW TO CLEAN-UP: Clean tools and spills with paint thinner or mineral spirits. DANGER!: HARMFUL OR FATAL IF SWALLOWED. KEEP OUT OF THE REACH OF CHILDREN CAUTION: For exterior use only. Contains petroleum based products. Keep away from heat, sparks and open flame. Use only with adequate ventilation. Eye and skin irritant. Persons with skin or respiratory sensitivity should not use product without sufficient protection. Avoid contact with skin and breathing vapor. If swallowed, do not induce vomiting. Call physician immediately. Seal container when not in use. Do not use in drinking water or food systems. CALIF. PROP. 65 • CHEMICAL WARNING (CALIFORNIA HEALTH AND SAFETY CODE #25249.5 ET SEQ). WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects or reproductive harm. Use proper protection and adequate ventilation, when using product. VOC/VOS - 250 g/L max. (2.07 lbs./gal.) COMPLIANCE: ASTM 6511, SCAQMD Rule # 1168. ASPHALT MINERAL FILLER MINERAL SPIRITS PENETREX OIL CELLULOSE FIBER LIQUID RUBBER Asbestos free product PATENT PENDING C.A.S.# 8052-42-4 C.A.S.# 68131-74-8 C.A.S.# 8052-41-3 PROPRIETARY MIXTURE C.A.S.# 65996-61-4 PROPRIETARY MIXTURE WARRANTY AND DISCLAIMER: For limited warranty and disclaimer information, contact the Gardner-Gibson, Inc. corporate office at 1-800-237-1155 or www.gardner-gibson.com. See MSDS for more info Gardner Asphalt Corp. • P.O. Box 5449 • Tampa, Florida 33675-5449 Phone: (813) 248-2101 • Fax (813) 248-6768 • www.gardnerasphalt.com L-05 031-F Leak Stopper® Composé De Réparation Caoutchouté Pour Toitures • Dure 2 à 3x plus longtemps que les autres composés de réparation pour toiture • Renforcé de fibres • S’applique à la truelle • Bouche instantanément les fuites provenant du toit • S’étire pour prévenir les fissures • Spécialement conçu pour les fuites difficiles • Taux de pénétration des plus élevés DESRIPTION : Le Composé de réparation Leak Stopper® marque une percée révolutionnaire dans le domaine du colmatage et de la réparation de toitures. Ce composé de colmatage caoutchouté longue durée est spécialement formulé pour pénétrer en profondeur dans les endroits endommagés et boucher instantanément les fuites provenant du toit! Le secret réside dans l’utilisation de PenetrexMC, une huile pénétrante unique qui s’introduit profondément dans la fente et la scelle complètement. Grâce à l’ajout de caoutchouc liquide, ce ciment plastique flexible haute performance forme un joint supérieur, étanche à l’eau, qui élimine les fuites critiques. PRÉPARATION DE LA SURFACE : La surface doit être propre et exempte de rouille, de saleté et de débris. APPLICATION : Utiliser une truelle pour étaler sur la surface endommagée du toit. Insérer un tissu de renfort après la première couche puis appliquer une deuxième couche sur le dessus du tissu. QUELLE QUANTITÉ ME FAUDRA-T-IL? Un gallon couvre environ 8 pieds carrés. À FAIRE et NE PAS FAIRE : Convient à des applications extérieures seulement. Porter des vêtements de protection. Ne pas utiliser sur des surfaces en plastique, élastomère EPDM, Hypalon ou sur un revêtement de toit en caoutchouc synthétique de type similaire. En cas de doute sur la compatibilité du produit, faire d’abord un essai sur une petite section avant d’en appliquer sur toute la surface. POUR DES RÉSULTATS OPTIMUMS : Il est fortement recommandé de renforcer la réparation d’une bande de tissu de renfort universelle. Travailler le matériau jusqu’à l’obtention d’une consistance égale sur la surface à réparer et à l’intérieur de celle-ci d’environ 1/8 po à 1/2 po d’épaisseur, en dépassant de deux ou trois pouces au-delà de la surface à réparer. Incorporer le tissu dans le ciment et le couvrir d’une deuxième couche de ciment. Former un bord en biseau avec du ciment à l’endroit où les cheminées, grilles de ventilation et autres saillies joignent la ligne de toiture. NE PAS EXPOSER À LA CHALEUR DIRECTE/AUX FLAMMES NI DILUER. On recommande d’appliquer le produit lorsque la température de la surface se situe entre 50° et 120 °F. Par temps plus frais (50 °F ou moins), ranger le produit dans une pièce chauffée (70° à 80 °F) pendant au moins 24 heures afin de faciliter l’application. Ce produit est formulé pour être utilisé à l’année longue. PRÉCAUTIONS : Porter des vêtements et lunettes de protection pendant l’application de ce produit. Lorsqu’on transporte ce produit, s’assurer que le couvercle est bien fermé, et que le seau est bien rangé en position stable et verticale. Éviter de laisser le seau se renverser au risque que le couvercle se desserre et qu’une fuite se produise. Ne pas transporter sur le siège de passagers ou à l’intérieur de l’habitacle d’un véhicule. Placer plutôt le produit dans l’aire de chargement du véhicule, et sur des chiffons de protection afin de prévenir les dommages dus à un déversement accidentel. Ne pas ranger à une température de plus de 100 °F. Le fabricant se dégage de toute responsabilité en cas d’application sur une surface plane pouvant être sujette à un mauvais drainage ou à la formation de flaques d’eau. Ne pas réutiliser le contenant vide. NETTOYAGE : Nettoyer les outils ou déversements à l’aide d’un diluant à peinture ou d’essence minérale. GARANTIE ET CLAUSE D’EXONÉRATION : Pour de plus amples renseignements sur la garantie limitée et les exonérations, communiquez avec le siège social de Gardner-Gibson, Inc. au 1 800 237-1155 ou à www.gardner-gibson.com. CODE DE PRODUIT 0311-GA-F FORMATS DISPONILBLES FORMAT UNITAIRE DIMENSIONS UNITAIRES NIVEAU DE REMPLISSAGE POIDS UNITAIRE 1 gal. 6,75 po x 6,75 po x 7,75 po 3,4 L 4,08 Kg EMB. CPU 6/caisse 025056007803 www.gardner-gibson.com Gardner-Gibson • P.O. Box 5449 • Tampa, Florida 33675-5449 Tél: (813) 248-2101 G-11