Installationsanleitung Alunovo Ambient LED-Light im PDF
Transcription
Installationsanleitung Alunovo Ambient LED-Light im PDF
ALUNOVO® Ambient LED-Light Wichtige Sicherheitshinweise/ Important Safety Instructions: Deutsch: Vor und während der Installation Netzstecker nicht einstecken! Alle Teile dürfen nicht feucht oder in Wasser in Berührung kommen. Nur für den Gebrauch im Haus geeignet. Bitte überprüfen Sie vor Installation und danach regelmäßig Kabel, Ladegerät und alle anderen Teile auf Schäden. Ist eines der Teile beschädigt, darf das Produkt nicht mehr benutzt werden. Reinigung nur mit trockenem Pinsel ohne Reinigungsmittel. Installation vor Kinderzugriff schützen. Englisch: Don‘t plug the transformer before or while installation. Keep all parts dry and away from water. For indoor use only. Check all parts regularly for damages. If any part is damaged, the product must not be used. Cleaning with dry brush only. Keep away from children! Montageanleitung Installation guide Installation (deutsch): 1. Prüfen Sie, ob das Netzteil vom Strom getrennt ist. 2. Verbinden Sie Netzteil und erste LED-Schiene. Dabei bitte auf Polung gem. Abbildung achten! Wenn die Polung einer oder mehrerer Schienen falsch ist, wird diese nicht leuchten. In diesem Fall bitte nochmal vom Strom trennen und die falsch gepolten LED-Schienen um 180° drehen und wieder verbinden. 3. Alle weiteren Schienen mit den mitgelieferten Kabelverbindern miteinander verbinden. Bilden Sie eine Schlange. 4a. Zur Befestigung am Alunovo Aluminium EVO2 Kabelakanal schieben Sie die LEDSchienen vorsichtig in die dafür vorgesehenen seitlichen Profile. 4b. Zur Befestigung an anderen Gegenständen (z.B. TV-Gerät) benutzen Sie die auf der Rückseite der LED-Schienen aufgebrachte Doppelklebeschicht in dem Sie das 3M-Trägerpapier zuvor abziehen. Das Klebeband lässt sich in den meisten Fällen auch nach Jahren entfernen. Installation (english): 1. Be sure that the transformer is not connected. 2. Connect the transformer with the first LEDbar. Check for the right polarity of the LED-bar (see illustration)! If one or more bars are connected in wrong polarity, they will have no function (no light). In this case, please disconnect the transformer first, disconnect the wrong connected bar(s) and connect them, after you turned them 180°. 3. Connect all further LED-bars with the delivered cable-connectors in a single row. 4a. For mounting the bars at the rear side of an Alunovo Aluminium EVO2 cable bus, please slide the LED-bar carefully in the slots on both sides of the aluminium cover. 4b. For mounting the bars at the rear side of an Alunovo Aluminium standard cable bus, please use the glueing tape on the rear side of the LEDbars and mount them at both sides (wings) of the aluminium cover. You can also use this tape to fit the LED-bars at the rear side of a TV or wherever you need a background ambient light. Probleme? Einfach anrufen / Problems? Give us a call: tel./pho.: +49 (0) 2173 1066170 email: [email protected] ©ALUNOVO 2008. All rights reserved. Alunovo, Kölner Str.16, 40764 Langenfeld, Germany. man/aal-02