Date: July 25 2013 SIEMIC Job Tracking No.: SC13072501

Transcription

Date: July 25 2013 SIEMIC Job Tracking No.: SC13072501
Date: July 25 2013
SIEMIC Job Tracking No.: SC13072501-ATC-006
IC Certification No.: 5011A-45503
Applicant Name: Estes-Cox Corporation
Address: 1295 H Street Penrose Colorado 81240 United States
Attention:
Dear Sir/Madame:
I am pleased to advise that this device meets our procedural and specification requirements for
certification.
The assigned certification number and the model number must be shown on each equipment model.
This certification identification information may be shown on the equipment model identification plate
or on a separate label that shall be indelible and tamper proof. The certification number shall be
prefixed with the letters “IC:”. Radio equipment is certified as described on the attached certificate.
Certificate is attached for the following model(s):
#4550-3
A website has been established which includes the status of applications.
The address is http://strategis.ic.gc.ca/app/sitt/reltel/search/newRadioSearch.do?language=eng
Sincerely,
Signature:
Leslie Bai
Director of Certification
SCS-F49: IC Certification Letter
Created By: Snell Leong
775 Montague Expressway, Milpitas, CA 95035 USA
Page 2 of 3
Tel : 4085261188
Fax : 4085261088 ,
Rev 5.0
Approved By: Leslie Bai
Email : [email protected]
TECHNICAL ACCEPTANCE
CERTIFICATE
CERTIFICAT D’ ACCEPTABILITÉ
TECHNIQUE
SIEMIC Tracking Number : SC13072501-ATC-006
SIEMIC Pistage du Nombre
Issued To:
Estes-Cox Corporation
DÉLIVRÉ A
1295 H Street Penrose Colorado
81240 United States
Test Lab IC Number : 5077A-2
Évaluez le nombre d'IC de laboratoire
Tested By :
Accurate Technology Co. Ltd
TESTÉ A
F1, Bldg. A, Changyuan New Material Port
Keyuan Rd., Science & Industry Park,
Nanshan District, Shenzhen
(Email) [email protected]
(Tel) 86 755 26503290
(Fax) 86 755 26503396
Issued Date:
Date Publiée
July 25, 2013
Certification No.:
No. DE CERTIFICATION
Type of Equipment :
GENRE DE MATÉRIEL
5011A-45503
Emission Designator :
Émissions Designator
2.4GHz two-channel
radio transmitter for use
with radio-controlled
model airplanes
1M70F1D
Trade Name & Model Number :
MARQUE ET MODELE
Radio Standards Specification (RSS) No., Issue & Date:
RSS SPÉCIFICATION/ ÉDITION & DATE
#4550-3
RSS-210 Issue 8 December 2010
Frequency Range(MHz)
RF Power (W)
Antenna Information
BANDE DE FRÉQUENCES
PUISSANCE H.F.
INFO SUR L’ANTENNE
2402-2480MHz
85.05 dBuV/m, 3 meter
Integral Antenna
“Certification of equipment means only that the equipment has met the requirements of the above-noted specification. Licence applications, where applicable to use certified
equipment, are acted on accordingly by the Industry Canada issuing office and will depend on the existing radio environment, service and location of operation. This
certificate is issued on condition that the holder complies and will continue to comply with the requirements and procedures issued by Industry Canada. The equipment for
which this certificate is issued shall not be manufactured, imported, distributed, leased, offered for sale or sold unless the equipment complies with the applicable technical
specifications and procedures issued by Industry Canada..”
La certification du matériel signifie seulement que le matériel a satisfait aux exigences de la norme indiquée ci-dessus. Les demandes de licences nécessaires pour
l’utilisation du matériel certifié sont traitées en conséquence par le bureau de délivrance d’Industrie Canada et dépendent des conditions radio ambiantes, du service et de
l’emplacement d’exploitation. Le présent certificat est délivré à la condition que le titulaire satisfasse et continue de satisfaire aux exigences et aux procédures
d’Industrie Canada. Le matériel à l’égard duquel le présent certificat est délivré ne doit pas être fabriqué, importé, distribué, loué, mis en vente ou vendu à moins d’être
conforme aux procédures et aux spécifications techniques applicables publiées par Industrie Canada..
.
I hereby attest that the subject equipment was tested and found in compliance with the above-noted specification .
J’atteste, par la présente, que le matériel a fait l’objet d’essai et a été jugé conforme à la spécification ci-dessus..
Signature:
Leslie Bai
Director of Certification
Canadian Certification
SCS-F49: IC Certification Letter
Created By: Snell Leong
775 Montague Expressway, Milpitas, CA 95035 USA
Page 3 of 3
Tel : 4085261188
Fax : 4085261088 ,
Rev 5.0
Approved By: Leslie Bai
Email : [email protected]

Documents pareils