1. - Canarm
Transcription
1. - Canarm
TORCHIERE FT-5 10/02 QUESTIONS OR CONCERNS CONTACT CANARM AT: TORCHERE FT-5 10/02 QUESTIONS OU INFORMATION COMMUNIQUEZ AVEC CANARM AU: 1-800-265-1833 (Anglais) 1-800-567-2513 (Français) Du lundi au vendredi entre 8:00H et 17:00H H.N.E. 1-800-265-1833 (English) 1-800-567-2513 (French) Monday through Friday 8:00 AM to 5:00 PM E.S.T. SAFETY PRECAUTIONS: MISE EN GARDE: 1. DO NOT PLUG IN LAMP TO POWER BEFORE INSTALLATION IS COMPLETE. 2. CAUTION: TO PREVENT ELECTRICAL SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. 1. NE BRANCHEZ PAS LA LAMPE DANS LA PRISE AVANT QUE VOUS AYEZ COMPLETEMENT FINI L’INSTALLATION 2. ATTENTION: POUR EVFFER UN CHOC ELECTRIQUE, PRESENTER LA LAME LARGE A LA FENTE LARGE ET POUSSER JUSQUAU FOND. INSTALLATION: * Product May Not Look Exactly As Shown In Figures. INSTALLATION: * Peut Différer De Illustration. Socket Assembly Note: If your lamp post and base are already assembled, please proceed to Step# 3. Douille 1. Post Post Base Cord 1. Thread the socket assembly onto the top post. On the floor lamp, thread all remaining posts together. Poteau Poteau Note: Some posts are not threaded. To assemble these posts together, push and twist to secure. Base 2. Thread the base onto the bottom post. Cordon Pull the extra cord out the side of the base. Style 1 Glass Style 2 Spinner Nut 3. “Style 1” - Remove spinner nut from socket. Position Glass on lamp and secure with spinner nut. Clips Fixture Socket “Style 2” - Squeeze the clips together around the socket. Slide the glass over the clips, then push the glass up snug to the fixture socket. 4. Install proper bulb type and wattage into the lamp. Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: (613) 342-5424, Fax: (613) 342-8437 N.B.: Si le poteau et la base de votre lampe sont déjà assemblés, veuillez passer à l'étape #3. Vissez la douille sur le dessus du poteau. Sur la lampe de plancher, vissez tous les poteaux ensemble. N.B.: Certains poteaux ne sont pas filetés. Pour les assembler, poussez et tournez pour les fixer en place. 2.Vissez la base sur le dessous du poteau. Tirez l'excès de cordon du côté de la base. Style 1 Ecrou Fileté Vitre Style 2 Pinces Douille De La Fixture 3. “Style 1” - Retirez l’écrou fileté de la douille.Posez le globe sur la lampe et serrez en place à l’aide de l’écrou fileté. “Style 2” - Serrez les pinces ensemble autour de la douille. Glissez la vitre sur les pinces et poussez la vitre vers le haut pour qu'elle repose solidement sur la douille de la fixture. 4. Posez l’ampoule de type et de wattage requis dans la lampe. Importé Par: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: (613) 342-5424, Fax: (613) 342-8437