Zenith Aircraft ZODIAC 601
Transcription
Zenith Aircraft ZODIAC 601
Copyright 2005, 2006 Gary B. Anderson, All rights reserved Cut along leading edge of vertical stabilizer Cut along four lines above canopy in front and in back Fold paper inward between fuselage halves. ● Cut out ● ● Zenith Aircraft ZODIAC 601 Main Spar and Main Gear Builders Manual Zenith Aircraft Company CH 601 Paper Airplane Fold paper in half. Take care that the fold is symmetrical. A trick to doing this is to back light the paper and line up the wing panels Folded Model Cut the model out using either scissors or a sharp knife. Fold the main spar in half before cutting. Cut out model STOL CH 601 Zenith Aircraft Company www.zenithair.com Revision 0.0 (09/22/07) © 2007 Gary B. Anderson Cut out Page 2 Fold spar in half again. Wing spar and wheels Fold fuselage tabs along fuselage to both sides. Fuselage tabs STOL CH 601 Zenith Aircraft Company www.zenithair.com Revision 0.0 (09/22/07) © 2007 Gary B. Anderson Wing Spar and Fuselage Tabs Page 3 Fold forward fuselage tabs inward. Forward fuselage tabs Fold rearward fuselage tabs inward. Rear fuselage tabs STOL CH 601 Zenith Aircraft Company www.zenithair.com Revision 0.0 (09/22/07) © 2007 Gary B. Anderson Fuselage Tabs Page 4 Fold wings and horizontal stabilizer outward. Tape edges of fuselage. Fold wings and horizontal stabilizer Bend gear legs down and place spar and gear on tape. Main spar and gear legs STOL CH 601 Zenith Aircraft Company www.zenithair.com Revision 0.0 (09/22/07) © 2007 Gary B. Anderson Wings and Main Gear Page 5 Tape spar and gear to wing as shown. Tape spar and gear to wing Tape front gear to strengthen as shown. Front gear STOL CH 601 Zenith Aircraft Company www.zenithair.com Revision 0.0 (09/22/07) © 2007 Gary B. Anderson Main Spar and Gear Page 6 Acquire an engine. The CH 601 requires three paper clips. Place engine on cowling alternating the smaller loop side to side. Engine Form the leading edge of the wing. Use a sharp straight edge to make three creases in the leading edge. Form leading edge STOL CH 601 Zenith Aircraft Company www.zenithair.com Revision 0.0 (09/22/07) © 2007 Gary B. Anderson Engine and Leading Edge Page 7 The leading edge should look like this. Leading edge profile Bend down the flaps a bit. Bend up the elevators a bit and you are ready to fly! Trim STOL CH 601 Zenith Aircraft Company www.zenithair.com Revision 0.0 (09/22/07) © 2007 Gary B. Anderson Leading Edge and Trim Page 8