Saber 250 - aboutshow
Transcription
Saber 250 - aboutshow
Rev1.5 Saber 250 Introduction: Saber 250 consists of 48pixel, and each pixel is a three-in-one full color LED lamp. The frame is made from aluminum alloy, which makes it very reliable, stable, and easy to install. The display can be installed by a certain amount of saber, with simply being controlled through computer, which displays images on the saber. Features: 1.Light weight Great convenience for event shows in transportation and installation. 2.Solid and pleasing structure Pleasing and solid panel lay ideal foundation for flat and firm led display. 3.Easy installation and dismantling Tool-free during installing and dismantling. 4.Humanitarian operation interface Graphic operation interface enables easy operation for engineers. 5.Protection Degree: IP65 Still available during raining. 1 Rev1.5 Saber 250 Specification (1)Structure Diagram Pixel Each pixel is one RGB 3-in-1 SMD LED (2)LED Parameter Wave Length(nm) NO. Item 1 Red chip 620~625 2 Green chip 520~525 3 Blue chip 465~470 (3)Pixel Parameter NO. Item 1 Pixel Pitch 2 Pixel Configuration Parameter 10.4mm/0.41inch RGB linear type 3-in-1 SMD LED (4)Module Parameter NO. Item Parameter 1 Product Code 2 Dimension 250(W)×20.8(H)×52.7(D)mm/ 9.84(W)x0.82(H)x2.07(D)inch 3 Resolution 24(W)×2(H) 4 Pixel Density 9216dots/m2 5 Brightness 6 Viewing Angle 7 Best Viewing Distance 8 Color Temperature 9 Working Voltage DC48V 10 Max Power Consumption ≤10.1W 11 Average Power Consumption ≤5.0W 12 Weight 13 Grey Scale 14 Colors 15 Refresh Rate --- 16 Scan Method Static status 17 Refresh Frame Speed 18 Control Method 19 Display Mode 20 Life-span 21 Blind Dot Rate 22 Control Distance 23 Storage Temperature / Humidity -10°C~+50°C / <80%RH 24 Operation Temperature/ Humidity -10°C~+45°C / 10%RH~90%RH 25 Protection Rating LX001-025-02 4800nits 140° Horizontal, 140° Vertical 13~34.7m / 42.7~113.8ft 6500~9500K 0.25kg/0.55LB 16bit 281trillion ≥60Hz PSU/M2 Processor 1920*1080 ≥50,000hours ≤0.02% 1.Saber and Saber ≤5m/16.4ft 2.Saber and PSU ≤30m/98.4ft 3.Between PSU ≤100m/328ft IP65(front)/IP65(back) 2 Rev1.5 Saber 250 Drawing Diffusers 3 Rev1.5 Saber 250 Connection Note: 1. The maximum output of each Power Supply Unit is 32 pcs. 2. The cable connected between the first Saber 250 and the Power PSU 2000 should be less than 30m/98.4ft. 1. La puissance maximale de chaque unité d'alimentation est de 32 pcs. 2. Le câble connecté entre le premier Saber 250 et le bloc d'alimentation électrique 2000 devrait être inférieure à 30m / 98.4ft. ! WARNING 1.The ventilation must not be impaired by covering the appliance with items such as newspapers, table cloths, curtains, etc. 2.The appliance does not require much attention. If you want to clean it, please use only dry cloths or a brush. ! Avertissement 1.Le ventilation ne doit pas être compromise par couvrant l'appareil avec des objets tels que journaux, nappes, rideaux, etc. 2.Le appareil ne nécessite pas beaucoup d'attention. Si vous voulez nettoyer, s'il vous plaît utilisez uniquement des chiffons secs ou une brosse. 4