BDM100 V.1242 Serial Programming System

Product Name:
BDM100 V.1242 Serial Programming System
Shipping Weight: 500 g.
The ECU must be removed from the car and is programmed by special spring contacts
without soldering on the circuit board. This method is used for example if a car has no
connection from the OBD connector to the ECU or for very new ECU versions. The best
tool for this is the BDM 100
Which way of programming is used, depends on manufacturer, model, year and the ECU
type in the car. Generally we use the “easiest” way of programming. So if a car can be
programmed by the OBD port, we will do it this way.
After the security entries for the OBD2 programming get more and more difficult, a new
possibility has come up for chip-tuning of ECUs with Motorola MPC555 – 565.
This generation of Motorola processors contain 448KB - 1MB Flash memory. That
memory cannot be read and programmed with an eprom programmer. Therefore it is
possible over the so called BDM interface, which must be implemented on every ECU
board. For that purpose there are mostly 10 solder pads on the PCB.
Alternative there are ECUs with 12 or 14 solder pads, which can be supplied with
operating voltage over these pads.
The BDM100 connects these solder pads of the BDM port with the WinOLS PC over
the USB bus. The BDM100 gets its operating voltage from the USB bus. The ECU
needs its own supply voltage of +12 volts.
The BDM100 is a universal reader/programmer (it does not require our RACE software
necessarily) that allows the user to read and program files in the ECU supplied with
MOTOROLA MPC5xx processor (essential).
The BDM100 requires the ECU to be open, "on the bench", as the reading/programming
operations are realized by linking a flat cable to specific area the ECU as demonstrated
in the picture below (the tool, on the other side, is linked to the USB port of a computer).
It allows also to create perfect copies of the whole software of an ECU (after having
read the original ECU software).
The software allows to read and program the WHOLE ECU content of:
●
29BL802 SSOP eprom file (or ROM memory with maps if eprom physically not
present);
●
MOTOROLA MPC5xx Processor file;
●
Serial Eprom content.
Please note that even in the case of the ECU blocking, due to the wrong checksum
recalculation, the ECU can always be reprogrammed and then retrieved (if the original
software has been previously stored).
Package includes:
●
BDM100 Interface.
●
ECU connecting cable with 3 adapters.
●
USB connecting cable.
●
12V Power Supply.