DiGiCo S21 UPDATE 1.01
Transcription
DiGiCo S21 UPDATE 1.01
DiGiCo S21 UPDATE 1.01 Une nouvelle version est disponible pour la console S21 Le lien du logiciel de la console se trouve ici : Link Le manuel se trouve ici : Link Il faut utiliser une clé USB formatée en FAT32 pour placer le fichier logiciel. ---------------------------------------------------------------------------------------------------------------------------------Please read and follow the upgrade instructions below carefully. This version is compatible with sessions from V1.0 If you are upgrading a console that is running a software version earlier than V0.10 The following procedure assumes that you reimaged your console SATA drive when we provided an upgrade for early consoles (ie you removed the card and copied the new image to it) – so please make sure that this is the case before proceeding. Do NOT attempt to use the procedure below until this has been done. If you have lost the information about this, please contact [email protected] When the console first runs the application after the upgrade, you will be prompted and required to enter the console serial number. This is located on the console rear panel. Once entered and validated this information will not be required again. If you are upgrading a console that is already running V0.10 or later (including consoles running current version V1.0) Follow the standard upgrade procedure below: Software upgrade 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Download the ZIP file (see link below) and extract/unzip the file named update.dcu on your computer Copy the unzipped file to the root folder of a USB key (please ensure that the file is in the ROOT folder and not in a sub folder – also ensure that it is called update.dcu) Switch the console off Insert the USB key in the console USB port Hold down the “Overview” button on the console worksurface (see image below) Switch the console on and keep the overview button held for about 5 seconds and then release it You should then see a series of icons on the screen starting with a clock icon Wait for the console application to boot Open the main menu and check the version number at the bottom of the screen – it should be V1.0.1 Power cycle the console Upgrade complete File : Update_S21_V1.01_V1.docx Page 1/2 DiGiCo S21 UPDATE 1.01 Pour chaque bac de 10 faders de la console il faut effectuer un upgrade du bac Firmware upgrade There is new worksurface code (V51) in the package that will need to be applied to both surfaces. The procedure is as follows: For one section at a time: a) Power off b) Power on while holding down both the 1st and 10th channel mute buttons down until you see the engine icon appear on screen and then release the buttons. c) Wait until the App starts and you should then see a progress display indicating that the upgrade has started – wait for this to finish d) Power off again and repeat the above procedure for the second section holding the 1 st and 10th channel mutes in that section (Mutes 11 and 20) e) Wait for the update to finish and power cycle the console again f) Open the Main Menu > Diagnostics view and check that both surfaces report code Version 51 File : Update_S21_V1.01_V1.docx Page 2/2