ÿþ1 4 0 1 D o l p h ` s L C
Transcription
ÿþ1 4 0 1 D o l p h ` s L C
Foxwood Close Foxwood Industrial Park Sheepbridge Chesterfield Derbyshire S41 9RB United Kingdom TECHNICAL DATA T: 01246 261 828 F: 01246 261 830 [email protected] www.par.gb.com DOLPH'SLC-705 Solvent Borne Air-Drying Lacquer Clear Page 1 of 2 DESCRIPTION LC-705 is a water-proof clear insulating lacquer suitable for encapsulating and protecting coils from humidity. LC-705 is widely employed on radio and television coils, as well as general electronics. It air-dries rapidly to produce a tough, flexible film, which is not as flammable as traditional nitro-cellulose lacquers. LC-705 conforms to US Military Specification MIL-I-17384A, Type G, Clear. ADVANTAGES Rapid air-drying Low flammability Good corona resistance Tough, flexible film, resistant to moisture & oil Conforms to MIL-I-17384A, Type G, Clear APPLICATIONS LC-705 offer low dissipation factor and good resistance to corona effect, as well as being water & oil proof. It is especially recommended for the following applications. Deflection chokes Water-proofing small coils Coating of paper insulated coils Coil winding adhesive TV & Radio coils PHYSICAL PROPERTIES Thermal rating Colour Specific gravity @ 25oC o Viscosity, Ford No8 Cup @ 25 C Build, DFT (ASTM D-115) Curing time on copper strip @ 25oC (ASTM D-115) Corrosive effect on copper Thinner Pack sizes 105oC Clear 850 50g/L 10 - 30 seconds 0.175mm 10 minutes None PAR T2 25 Litre ELECTRICAL PROPERTIES Electric strength, dry (ASTM D-115) Electric strength, 24 hours in water (ASTM D-115) 1,000 Volts/0.025mm 600 Volts/0.025mm CHEMICAL RESISTANCE Water Acid, 10% sulphuric Alkali, 1% sodium hydroxide Salt water Mineral oil (ASTM D-115) Excellent Excellent Excellent Excellent Excellent Registered trademark Statements, technical information and recommendations contained herein are based on tests we believe to be reliable but they are not to be construed in any manner as warranties expressed or implied. The user shall determine the suitability of the product for their intended use and the user assumes all risk and liability whatsoever in connection therewith. TECHNICAL DATA DOLPH'SLC-705 APPLICATION DIP IMPREGNATION OR BRUSH LC-705 may be applied via dip or brush as supplied. SPRAY For application via spray, LC-705 should be thinned by 20 - 25% with PAR T2 Thinner. HEALTH & SAFETY Before use, please refer to Material Safety Data Sheets (MSDS). Page 2 of 2