condensation-kit

Instruction Sheet For NSF Tank Kit Installation
Kit Part No. 97707C
Foam insulation to be placed around
tank base as shown.
Presstite cork tape to be placed
in between foam insulator and
styrofoam jacket just above water lines,
as shown, for additional insulation. To
assist with installation, the tank assembly
can be lifted up by removing the hold
down screw that secures the tank base
to the water cooler shelf. Be careful not
to move the tank too far. If the tank is
moved too much the water and refrigerant lines can be damaged or broken.
After installation of the additional
insulation the tank assembly should be
re-secured with the hold down screw.
Styrofoam Jacket
Presstite Cork Tape
Tank Base
Foam Insulation
NOTE: Cover uninsulated water lines
with supplied armaflex tubing. Slit the
armaflex tubing and slip over the water
lines. Use electrical tape to secure the
armaflex tubing in place. The extra cork
tape can be used to insulate the water tube
elbow connection. (Not all units use the
water tube elbow connection)
PRINTED IN U.S.A.
IMPRESO EN LOS E.E.U.U.
IMPRIMÉ AUX É.-U.
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620
PARA PIEZAS, CONTACTE A SU DISTRIBUIDOR LOCAL O LLAME AL 1.800.323.0620
POUR OBTENIR DES PIÈCES, CONTACTEZ VOTRE DISTRIBUTEUR LOCAL OU COMPOSEZ LE 1.800.323.0620
97708C (REV A - 4/01)