S-STP500 - Pioneer
Transcription
S-STP500 - Pioneer
01 speaker system.fm 1 ページ 2006年3月23日 木曜日 午後4時7分 www.pioneerelectronics.com OPERATING INSTRUCTIONS S-STP500 1 2What's in the box Check that you have all the supplied accessories before you start: • Front speakers x 2 SPEAKER SYSTEM Making receiver settings Before connecting the speakers, please read the Operating Instructions supplied with your VSX-416 receiver to make the following settings: • Switch the speaker impedance to the 6 Ω setting (see Switching the speaker impedance to do this). • Center speaker x 1 • Set the crossover frequency to 200 Hz (see Crossover network to do this). After connecting the speakers, please complete Using the Quick Setup with the 5.1ch setting (refer to the receiver’s 5 minute guide in the supplied Operating Instructions). • Surround speakers x 2 Connecting the speakers • Speaker cords x 1 • Non-skid pads To get the best out of your speakers it is important that you connect them properly to your amplifier or receiver. Each speaker connection consists of a positive (+) and a negative (–) terminal. These should be matched between the amplifier and the speaker. • Brackets for wall mounting x 4 Important • Screws x 4 • These operating instructions • Make sure all equipment is turned off before making any connections. 1 Twist and pull off the protective shields on each speaker wire. Before you start Thank you for buying this Pioneer product. Please read through these operating instructions before installing and using your speaker system. Important In order to prevent damage to the speaker system resulting from input overload, please observe the following precautions: • Do not supply signal to the speaker system in excess of the maximum permissible input. • When connecting or disconnecting cables, make sure that your amplifier is switched off. • Do not use excessive amplifier volume if using a tone control to emphasize high or low frequencies. Caution • Do not connect the supplied speakers to any amplifier other than the one supplied with this system. Connection to any other smplifier may result in malfunction or fire. • Pioneer will not be responsible for any accidents or damage that may result from improper installation. 2 Attach one end of the supplied speaker cord to the rear of the center speaker. Connect the wire with the colored marker to the red (+) terminal; the plain wire to the black (–) terminal. Press down the spring-loaded tab and insert the wire, as shown below. Release the tab to secure the wire. Red (+) Black (–) Green colored marker 01 speaker system.fm 2 ページ 2006年3月23日 木曜日 午後4時7分 3 Connect the other end of each speaker cord to your receiver. To connect, insert the colored wire into the matching positive (colored) terminal and the other wire into the negative (black) terminal as shown below. See also the Operating Instructions that came with your receiver. Placing the speakers • The diagram below shows the standard speaker placement relative to your listening position. Center Surround right Surround left Front left Front right Subwoofer color-coded wire Listening position Gray VSX-416 SUB WOOFER PREOUT S P E A K E R S R FRONT LR SURROUND L Blue Surround left CENTER Surround right The following guidelines will help you to get the best performance from your speaker system. See also the section on Connecting the speakers in the Operating Instructions that came with your receiver. Green Front right Front left Center • The distance between the front speakers should be about the same as from your listening position to each speaker. Place them at an equal distance either side of your TV and roughly at ear-level (when you are seated in your usual listening position). • You may want to angle the speakers slightly inward for better image stability, especially for listeners who are not right in the center. • Placing the speakers close to the rear or side walls will enhance the mid-bass performance, although too close (especially to a corner) may result in boomy bass and degraded stereo image. Red White Caution • Confirm that all bare speaker wires are twisted together and inserted fully into the proper terminals. If a bare wire strand touches the rear panel, a short circuit may cause the protection function to operate, disconnecting power to the unit. • The left and right surround speakers should be placed at about ear-level. Depending on the layout of your room, the left and right surround speakers may be mounted on the side walls. • Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen. Caution • Do not attach the center speaker to the wall or ceiling. It may fall off and cause injury. If you choose to install the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or damaging the speaker. • Do not install speakers near a stove or other heating appliance, or put them in a place exposed to the sun. Such locations may cause the cabinet to change color and the speaker system to break down. • The front, center and surround speakers supplied with this system are magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker is installed extremely close to the screen of a television set. If this happens, turn the television set off for 15 to 30 minutes before switching it back on. If the problem persists, place the speaker system away from the television set. 01 speaker system.fm 3 ページ 2006年3月23日 木曜日 午後4時7分 Non-skid pads Attach the non-skid pads to the base of the speakers. Use the supplied adhesive to attach 4 pads to the base (flat surface) of each speaker. Troubleshooting Symptom Possible cause Remedy No sound • Bad speaker wire or connection • Receiver is off • Volume control is at zero • Connect correctly or replace wire. • Turn on receiver. • Slowly turn up volume. Sound is distorted • Extreme signal condition • Turn down the amplifier’s output level (volume, bass control, bass boost) to lower the level. Speakers stop • Extreme signal producing condition for extended sound suddenly period of time • Turn the volume down to resume normal speaker output. Caution Cabinet maintenance Use a polishing cloth or dry cloth to wipe off dust and dirt. If the cabinet is very dirty, clean with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and then wipe again with a dry cloth. Do not use furniture wax or cleaners. Never use thinners, benzene, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. Wall-mounting the front and surround speaker system Attaching the brackets • Make sure to tighten the supplied screw as securely as possible when attaching the bracket to the back of the speaker. • Please do not attach the brackets to the center speaker. Before mounting • Remember that the speaker system is heavy and that its weight could cause the wood screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. Make sure that the wall on which you intend to mount the speakers is strong enough to support them. Do not mount on plywood or soft surface walls. • Mounting screws are not supplied. Use screws that are suitable for the wall material and that will support the weight of the speaker. • These speakers are equipped with a protection device to protect the transducers from extreme conditions. Under these conditions the protection device will activate and stop the speaker from producing sound. If this happens turn the volume down to resume normal speaker output. Specifications Front / Surround speakers Enclosure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Closed-box bookshelf type (magnetically shielded) System. . . . . . . . . . . . . . . . . . . . . . . . . . . . 7.7 cm 1-way system Speakers Speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7.7 cm cone type Nominal impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Ω Frequency range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85 Hz to 20 kHz Dimensions. . . . . . . . . . . . . . . . 105 mm (W) x 115 mm (H) x 114 mm (D) Weight Front speakers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.6 kg Surround speakers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.66 kg Center speaker Enclosure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Closed-box bookshelf type (magnetically shielded) System. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7.7 cm 1-way system Speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7.7 cm cone type Nominal impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Ω Frequency range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80 Hz to 20 kHz Dimensions. . . . . . . . . . . . . . . . . 270 mm (W) x 90 mm (H) x 100 mm (D) Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.8 kg Note • If you are unsure of the qualities and strength of the walls, consult a professional for advice. • Pioneer is not responsible for any accidents or damage that result from improper installation. Bracket screw (supplied) Mounting screw (not supplied) 5 mm to 7 mm 5 mm 10 mm Note: Specifications and design subject to possible modification without notice due to improvements. 01 speaker system.fm 4 ページ 2006年3月23日 木曜日 午後4時7分 Published by Pioneer Corporation Copyright ©2006 Pioneer Corporation All rights reserved PIONEER CORPORATION 4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS (USA) INC. P.O. BOX 1540, Long Beach, California 90810-1540, U.S.A. TEL: (800) 421-1404 PIONEER ELECTRONICS OF CANADA, INC. 300 Allstate Parkway, Markham, Ontario L3R OP2, Canada TEL: 1-877-283-5901 PIONEER EUROPE NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium TEL: 03/570.05.11 PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-7555 PIONEER ELECTRONICS AUSTRALIA PTY. LTD. 178-184 Boundary Road, Braeside, Victoria 3195, Australia, TEL: (03) 9586-6300 PIONEER ELECTRONICS DE MEXICO S.A. DE C.V. Blvd.Manuel Avila Camacho 138 10 piso Col.Lomas de Chapultepec, Mexico,D.F. 11000 TEL: 55-9178-4270 <06D000001> Printed in China K002_A_En <SRB1336-A>