Complete systems for: radiant floor heating/cooling/plumbing.
Transcription
Complete systems for: radiant floor heating/cooling/plumbing.
ACOME Complete systems for: radiant floor heating/cooling/plumbing. Plumbing systems Hot and cold water distribution Principle: The appliances (plumbing, radiators, fan-coil units, etc.) are individually supplied from a header / distributor. Direct connection, without discontinuity or couplings, is done by ducted PEX-c or PB pipes incorporated into the structures (see diagrams) or by surface-mounted multi-layers. A complete system – The components: • PEX-c, PB or multi-layer pipes (with or without ducts) which meet with international requirements (see page 4, pipes can be supplied by ACOME). • Complete range of NF or DIN crimped fittings • Accessories for inlets and outlets in structures • Header / Distributor • Valves and accessories • Manual or battery-operated crimping guns A large number of advantages: • Easy installation = less time required Fewer nuisances = absorption of circulation area noises, decreased heat losses • Increased safety = elimination of pipework corrosion and furring • Complete system with adapted components that comply with regulatory restrictions. DEPARTMENT BUILDINGS - 52, rue du Montparnasse - 75014 Paris - France - Tél. : +(33) 1 42 79 14 00 - Fax : +(33) 1 42 79 15 00 E-Mail : [email protected] - Site : www.acome.com Réf. DBAT 02/2005 - 253 AN - 991188 Hydraulic and electric Four comple ACOME under floor heating systems are used to provide total or partial heating or heating/coolin apartment blocks, and in the business sector: offices and factories. They are fully adapted to schoo stadiums. They can also be used outdoors to prevent the formation of black ice, as solar panels, etc Hydraulic under floor heating / cooling Installed with a concrete slab or a wet screed Skirting Anti-shrinkage web (if required) WALL / PARTITION Permanent elasticity joint Concrete slab or wet screed Peripheral insulation PEX-c pipe Floor finish Isolation slab on pads Support More than 20 years experience and references: over 30,000,000 m2 of Acome floors have been laid across the world Hydraulic under floor heating Dry solution, installed without any concrete Innovation prizes Nominated at the Paris international Interclima 2004 trade show Installed within 22 mm! Skirting Permanent elasticity joint WALL / PARTITION Peripheral insulation 2 PEX-c pipes PE /aluminium undercoat PSE slab with aluminium film al thi Re Floating floor Support 22 m • Thin system: taking 22 m • Lightweight system: very • System that can be laid o • Easy system: very quick i • Dry system: premises are DEPARTMENT BUILDINGS - 52, rue du Montparnasse - 75014 Paris - France - Tél. : +(33) 1 42 79 14 00 - Fax : +(33) 1 42 79 15 00 E-Mail : [email protected] - Site : www.acome.com Réf. DBAT 02/2005 - 253 AN - 991188 c under floors heating ete systems ng. They can be used to cover all site configurations: new or retrofit works for family homes and ls, hotels, restaurants and churches as well as sports complexes: gymnasiums, swimming pools and c. Skirting WALL / PARTITION Permanent elasticity joint Anti-shrinkage web (if required) Concrete slab or wet screed Peripheral insulation Permanent output cable on plastic mesh grid Floor finish Isolation slab on pads Underfloor form (if required) Support Electric under floor heating, self-regulating cable Dry solution, installed without any concrete A real innovation! Installed within 22 mm! A world first: an easy to install round section self-regulating cable Skirting Permanent elasticity joint Floating floor Peripheral insulation PSE slab with aluminium film PE /aluminium undercoat Self-regulating cable WALL / PARTITION icknes s Electric under floor heating, permanent output cable Installed with a concrete slab or a wet screed Support mm mm y little added load over existing floor installation immediately usable DEPARTMENT BUILDINGS - 52, rue du Montparnasse - 75014 Paris - France - Tél. : +(33) 1 42 79 14 00 - Fax : +(33) 1 42 79 15 00 E-Mail : [email protected] - Site : www.acome.com Réf. DBAT 02/2005 - 253 AN - 991188 Customised systems The components: With over 20 years experience and references across the world, ACOME obviously to be your industrial partner, allowing you to provide your clients with complete solutions, whether for hot and cold water distribution, radiators and convectors or for hydraulic or electric under floor heating systems. A few examples: • The PEX-c pipe ACOME provides a full range of pipes, from DN 12 to DN 25, either uncovered or ducted. • PSE pipe-guide slabs ACOME provides a range of PSE slabs, thickness according to requirements, for floor heating systems. • Header/distributor kit This kit distribution between the generator and the heating unit. … /… The components meet the standards and certifications in force in the following countries: STANDARD DIN 4726 DIN EN 15875 CERTIFICATION DIN CERTCO Germany CERTIFICATION UNE EN 15875 AENOR DIN 4726 DIN EN 15875 DIN CERTCO CSA B 137.5 CSA DIN 4726 DIN EN 15875 DIN CERTCO DIN 4726 DIN EN 15875 DIN CERTCO Spain BRL 5606 BRL-K536 / 04 KOMO KIWA Netherlands Switzerland BS 7291 BBA Canada GB ASTM F876 / F877 NSF 14 NSF ICC USA Czech Republic NF T 54085 Technical assesment CSTBat certification Attestation of Sanitary Conformity DIN 4726 DIN EN 15875 DIN CERTCO France Italy STANDARD Belgium Please contact us for any further information required concerning our systems. DEPARTMENT BUILDINGS - 52, rue du Montparnasse - 75014 Paris - France - Tél. : +(33) 1 42 79 14 00 - Fax : +(33) 1 42 79 15 00 E-Mail : [email protected] - Site : www.acome.com Réf. DBAT 02/2005 - 253 AN - 991188 ACOME worldwide Industrial facilities – France: Mortain / China: Wuhan and Xintai / Brazil: Irati Subsidiaries ans offices Agents and distributors Three fields of activity, systems dedicated Building sector Electrical equipment Telecommunications A few references … 1 2 • Castello-Vigevano (Piemonte - Italy)1 • Versailles Castle (Versailles – France) • San Gregorio church (Milan – Italy) • TGV Lyon/Satolas (Lyon – France)2 • British Museum (London – GB) • Bercy Exhibition (Paris – France) • Institut du Monde Arabe (Paris – France) • Notre Dame de Fatima church ( Zapopane – Poland) • Benetton factory (Trévise – Italy) • Fabriano (Ancona - Italy)3 • Danone research centre (Palaiseau – France) • Castello-Vigevano (Piemonte - Italy)4 3 • Skating rink (Courchevel – France) 4 And a large number of industrial, residential and apartment block projects. DEPARTMENT BUILDINGS - 52, rue du Montparnasse - 75014 Paris - France - Tél. : +(33) 1 42 79 14 00 - Fax : +(33) 1 42 79 15 00 E-Mail : [email protected] - Site : www.acome.com Réf. DBAT 02/2005 - 253 AN - 991188