Technical Data
Transcription
Technical Data
Typ: FETR 101.715#21 Art.-No.: UN030109 Features: Fußbodentemperaturregler, elektronisch, UP, 10...50°C, Merkziffernskala, mit Deckelset und Rahmen, Schließer, 230VAC, 16(2)A, reinweiß ähnlich RAL 9010 Application: Temperature control (e.g., of electrical heating systems) for floor, fringe zone, bathroom, ceiling, tiled stove, marble and wall heating systems or tempering systems, direct floor heating systems. Reduction: With these flush-mounted controllers, the temperature can be reduced by 5 K. For this purpose, potential is applied to the clock input terminal by an external pilot controller or an external timer L1. Note: The sensor line is to be routed in a protective duct. Parallel routing together with lines that carry AC voltage is not permissible. The 55 x 55-mm variants visually fit perfectly without an intermediate frame in many switch ranges of 55 x 55 mm. Using an intermediate frame, the 50 x 50-mm variants visually fit in almost all switch ranges. Technical Data: Dimensions of housing: Dimensions of packaging: Reduction: Number of outputs: Number, control range: 81 x 42,5 x 85 mm 115 x 60 x 115 mm yes 1 1 Output signal: External setting: Configuration: operating elements: Operating mode off with frost protection monitoring: Operating voltage: Design: Eco function: Input of temperature reduction: setting range to: setting range from: Electrical connection: Electrical direct heaters: Electrical floor heating: : Colour of housing: Sensor: Sensor rupture and short circuit safeguarding: Sensor wire extendable up to: Sensor type: Weight: Heating: Output, heating: Hysteresis: Stove heating: Storage temperature: Scope of supply: Material of housing: max. switching voltage: max. switching current: mechanical range setting: Medium: min. switching voltage: Installation/fastening: Surface quality: potential-free: Control range up to: Control range from: Control function: Switching element: ON/OFF switch: Switching contact: Heizen, schaltend (230 VAC, 50 Hz) yes Fußbodentemperaturregler Merkziffernskala 1...5 no 230 VAC, 50 Hz Berlin UP yes ca. 5 K (230 VAC, 50 Hz) 50 10 Schraubklemmen yes yes Kleinspannung, nicht galvanisch getrennt reinweiß, ähnlich RAL 9010 extern, NTC Heizung wird abgeschaltet 50 m mit min. 0,5 mm² doppelt isoliert HF-8/4-K2 ca. 300 g yes yes yes -20...+70 °C Regler, Fernfühler 4m, alre-Rahmen "Berlin" (neutral), Abdeckung 50 x 50 mm reinweiß (ähnlich RAL 9010), glänzend Kunststoff PC 230 VAC, 50 Hz 16 (2) A yes Luft, nicht aggressiv 230 VAC, 50 Hz in UP-Dose (tiefe UP-Dose empfohlen) glänzend no 50 10 Heizen Relais yes Schließer Switching power: Degree of protection: Protection class: Safety and EMC: Set point adjuster: Ambient temperature up to: Ambient temperature from: Accessories: Permissible atmospheric humidity: Ciruit Diagram: 3680 W IP 30 II, nach entsprechender Montage gemäß DIN EN 60730 yes 40 0 Klemmenleisten: VOOPL / VOOPD passende Ventilstellantriebe: ZBOOA-010.100 max. 95% r. H., nicht kondensierend