Chimney flues cutter 700 FV E
Transcription
Chimney flues cutter 700 FV E
CHIMNEY FLUES CUTTER ROCHET 40 years in the ceramic industry ZI – BP 25 – F09101 PAMIERS cedex France Tel : 33 (0)5 34 01 35 00 – Fax 33 (0)5 34 01 35 01 http:// www.coupeur-rochet.fr E-mail : [email protected] Ours cutters are : Simple Rapid Precis Reliable Chimney flues cutter (FV) ROCHET Cutting The cutting is made by a vertical and oblique thread activated by one motorcycle - reducer brake which starts and stops in every cutting. The started of the engine is realized by a contact commanded by the chain beforehand of the mobile wagon and the stop by the slow tree of the reducer. The thread moves at first from left to right, then from right to left. The slope of the thread allows to reduce the deformations of the walls of the product during the cutting. A modification of some seconds allows to make cuttings always in the same sense. Adjustable side rollers by steering wheels prevent any movement of the product during the cutting. Carriage moving Les guidages sont réalisés au moyen de douilles à billes de grande précision. The training of the wagon is obtained by a chain making a tour by cut product. This chain is pulled by an engine with resolver assuring a very big precision of cutting. An incrémental converter analyzes permanently the speed of exit of clay and determines the speed of rotation of the engine. The guides are realized by means of cartridges with balls of big precision. Synchronisation The table motion is synchronised with the clay cake advance, to give perfectly square cuts. Cutting rates With 1 wire : 3 000 cuts / hour Cutt-off length The cutting length are determined by a pinion ratio : All the cutting lengths can be obtained to within 1 millimetre. Cutting length precision : 2 millimetres. Cutting capacity Breadth : 400 – 700 millimetres or more depending on the cutter size. Height : 450 - 600 millimetres with standard cutters Minimum length : 40 millimetres Maximum length : 600 millimetres with standard cutters (more upon request). Maintenance The ROCHET CUTTER does not require maintenance. Special device Sur demande, possibilité d’équiper le coupeur FV de dispositifs pour : • Automatic wire unwinding drum : no need to change the wire, no need to stop the moulder. A wire of smaller diameter can be used for even better cuttings. • Cutting counter. • Counter to obtain precut halves at a determined percentage. • Long cutting : cutting up to 1800 mm. • Recutting of roman tile lateral spigots. 30/05/01 – Specifications liables to change without notice.